adeptus Jennifer 78114 Manual de instruções de montagem - Página 11

Procurar online ou descarregar pdf Manual de instruções de montagem para Mobiliário de interior adeptus Jennifer 78114. adeptus Jennifer 78114 12 páginas. End table

Imprimir página

ATTACH THE RIGHT AND

LEFT DRAWER RUNNERS.

TIP: To make this step easier, place the drawer

upside down on a counter with the drawer front

hanging off the edge. This will allow the drawer

box to lay flat and provide better control for

tightening the screws. DO NOT OVER-TIGHTEN!

ENSURE THE

WHEEL IS TOWARDS

THE BACK AND THE

RUNNER IS PUSHED

COMPLETELY

FORWARD,

TOUCHING THE

DRAWER FRONT.

F=06

G=01

3,0 x 16mm

INSERT THE DRAWER

Tilt the back of the drawer upward to get it past

the wheels on the drawer runners.

Once clear of the wheels, you can level the

drawer and slide it in.

Complete these steps for both the left and the right side of the drawer.

NOTICE:

H=01

Left Set Right Set

• Loosen the screw (part F) you used to

install the drawer runner to the side panel

(parts 02 or 03), depending on the side

(left or right), as shown.

• With the screw (part F) loosened, you can

make the necessary slight adjustments (up

or down) to the drawer runner to achieve

the proper drawer front alignment.

ENSURE THE SCREWS ARE INSERTED

THROUGH THE CORRECT HOLES IN

THE RUNNER. SEE THE ENLARGED

DIAGRAM ABOVE.

CONTAINED

After completed assembly, it is

necessary to adjust the drawer

alignment to get the drawer

perfectly square.

Once the drawer

alignment is square,

secure the position of the

drawer runners to the side

panels by re-tightening

the part F screw.

F=02

3,0 x 16mm

11-12