DDK CM10-SP10S-S(D6) Manual de montagem - Página 6
Procurar online ou descarregar pdf Manual de montagem para Cabos e conectores DDK CM10-SP10S-S(D6). DDK CM10-SP10S-S(D6) 12 páginas. Plug connector cable
Imprimir página3-5. Inserting a contact
Insert the contact into the specified terminal number point in the housing.
(Insert grounding wire or drain wire into terminal No. 10).
* When the contact catches the housing, you will hear a snap.
* Pulling the wire for confirming the correct position.
Note! Before inserting the contact, check that the clamp nut, cable clamp, bushing and angle back
shell is inserted.
Take care not to insert the contact upside down as shown below.
Contact
* Insert the contact so that the terminal
number face the same direction.
However, in case of CM10-SP2S(D6), insert the
contact so that the lance and the terminal
number face the opposite direction.
* Using a pull out tool for pulling up inserted contact.
Tool No.: 357J-50548T
Refer to the instruction manual in case of using
pull up tool.
* As Lance falls down easily after pulling up,
set up to original position before re-insert.
Housing
Cable
Insert
Lance
Lance
Material No.
Terminal No. 10 only
(Grounding wire or drain wire)
Terminal No.
CM10-SP10S(D6)
Contact
Terminal No.
Contact
CM10-SP2S(D6)
Page
TC-605
5/11