Gallien-Krueger 700RB/112 Manual do Proprietário - Página 5
Procurar online ou descarregar pdf Manual do Proprietário para Amplificador Gallien-Krueger 700RB/112. Gallien-Krueger 700RB/112 17 páginas. 700rb series
Imprimir página
The 700RB Series is designed to be simple to operate.
All controls have a well defined purpose and are well
behaved. These directions will take you through the
basics and give you a good start for setting up your
sound.
Set the power switch to Off and connect the supplied
power cable, from the amplifier AC receptacle, to an AC
power outlet of proper voltage and power rating (see
safety information on page 7 for details).
Connect your speaker cabinets to the amplifier outputs
marked 380W AMP ONLY or "SPEAKON" OUTPUTS.
Be sure not to exceed the recommended speaker load
below.
One 4 Ohm, or two 8 Ohm cabinets on the 380W Amp.
One or two 8 Ohm horns on the 50W Amp.
If you are using an RBH Series cabinet, use the supplied
4 conductor Speakon cable to connect to the "Speakon"
outputs on the rear panel of the amplifier. Set the Woofer
X-Over and Tweeter Hi Cut switches on the front panel to
the IN position. In addition, set the switch on the RBH
cabinet to Bi-Amp.
For connection to all other cabinets, connect to the 1/4"
outputs labeled 380W amp only. Set the Woofer X-
Over switch on the front panel to the Out position.
For more information on Bi-Amp and Normal Operation,
see page 7.
Do not connect the Speakon cable labeled "Bridge Mode"
to the 700RB. This may result in damage to the ampli-
fier.
Set all EQ controls and the Boost control to 12 o'clock.
The Voicing Filters should be turned all the way down to
get a flat response. Set the Volume and Master Volumes
at 0. If you have a five string bass, push the button
marked String Bass in.
Using an instrument cable, connect your bass to the
Input jack and turn the power switch on and play. If the
input clipping LED flashes, push the button marked
in. This will prevent you from overdriving the
preamp.
Set the volume control to 12 o'clock and slowly bring the
Master volume up. Do not turn the Volume control in
the input section past 12 o'clock unless you want an
overdrive effect. If you have a bass with passive electron-
ics make sure the controls are all the way up. If you
have a bass with active electronics, turn all of the EQ
controls on the bass to the middle or flat position.
You should be hearing your bass quite well. You can use
the Volume and Woofer-Master to achieve a comfortable
sound level.
If you need more volume, turn
up the Woofer-Master control first.