Gallien-Krueger Legacy 212 Manual do Proprietário - Página 6
Procurar online ou descarregar pdf Manual do Proprietário para Amplificador Gallien-Krueger Legacy 212. Gallien-Krueger Legacy 212 10 páginas. Combo
Imprimir página
LEGACY SERIES COMBOS
Quick Start
The Legacy Combos are designed to be simple
to operate and all controls have a well defined
purpose. These directions will take you through
the basics and give you a good start for setting
up your sound.
Connect your speakers: Connect your
extension
speaker
amplifier outputs marked SPEAKER
using a standard two conductor speakon
cable or Gallien-Krueger four conductor
speaker cable. Using the Load Impedance
switch, select the speaker load that
matches the total impedance of the
attached speaker cabinets.
Maximum
recommended
loads: One 4 Ohm, or Two 8 Ohm
cabinets.
Initial front panel control settings: Trim
knob to the full clockwise position. Drive,
Level
and
Master
clockwise position. All EQ and Edge
controls to the 12 o'clock position. Bump,
Contour, Presence and Mute to the down
position.
Connect your Instrument: Using a
shielded ¼" instrument cable, connect
your bass to the input jack and press the
power switch to the on (up) position. If
you have active tone controls on your
bass, turn all of the controls to the middle
or flat position and turn the volume all the
way up. If you have conventional, passive
tone controls, turn all tone and volume
controls all the way up.
Level and Master Volume settings:
Using a shielded ¼" instrument cable,
connect your bass to the input jack and
press the power switch to the on (up)
position. If you have active tone controls
on your bass, turn all of the controls to the
middle or flat position and turn the
volume all the way up. If you have
cabinets
to
the
speaker
to
full
counter
conventional, passive tone controls, turn
all tone and volume controls all the way
up.
Drive Settings: Place the Overdrive
switch to the up position. Turn the Drive
knob to the 12 o'clock position. Turn the
Level knob up as you play to the desired
volume. You can now experiment with
various Drive settings. *As Drive is
adjusted it may be necessary to adjust the
Level knob
to maintain consistent volume level.
5