Gallien-Krueger MB FUSION Manual do Proprietário - Página 5
Procurar online ou descarregar pdf Manual do Proprietário para Amplificador Gallien-Krueger MB FUSION. Gallien-Krueger MB FUSION 12 páginas.
Imprimir página
Quick Start
The MB Series amplifier is designed to be simple
to operate. All controls have a well defined
purpose. These directions will take you through
the basics and give you a good start for setting up
your sound.
1. Plug it in: Set the power switch to Off and
connect the supplied power cord, from the ampli-
fier AC receptacle, to an AC power outlet of proper
voltage and power rating (see safety information
on page 5 for details).
2. Connect your cabinets: Connect your speaker
cabinets to the amplifier outputs marked Speaker.
The MB features dual use speaker connections.
These unique jacks allow for Speakon or 1/4"
plugs to be used. Be sure not to exceed the recom-
mended speaker load as noted below.
Maximum Recommended Speaker Loads: One
4 Ohm, or two 8 Ohm cabinets.
3. Initial front panel control settings: Set all EQ
controls and contour knob to 12 o'clock. Set the
Gain A, Gain B, Master A and Master B controls at
0. The A/B button (between Bass and Master A
knobs) should be in the out position.
4. Plug in your bass: Using an instrument
(shielded) cable, connect your bass to the input
jack and press the power switch on. If you have
active tone controls on your bass, turn all of the
controls to the middle or flat position and turn the
volume all the way up. If you have conventional,
passive tone controls, turn all tone and volume
controls all the way up.
5. Level and Master Volume settings: Set the
Master A volume to 3 o'clock. Turn the Gain A
knob up as you play to the desired output level. If
distortion occurs at low gain settings press the
-14db pad button in and turn the Gain A volume
knob up. If the signal is still distorting, reduce the
volume on your bass.
MB FUSION
6. Boost/Master B: Engage the button located
between the boost and master B knobs. This will
activate the boost section of the pre amp. This can
also be done with the included foot switch. Turn
up the Gain B and Master B knobs to the desired
volume and gain levels.
You should be hearing your bass quite well
through the Master A and Master B channels. At
this point you can experiment with different EQ,
Contour and Gain settings.
5