HighSecLabs MDR102 Manual de configuração rápida

Procurar online ou descarregar pdf Manual de configuração rápida para Leitor de cartões HighSecLabs MDR102. HighSecLabs MDR102 2 páginas. Secure 2-port and 4-port multi-domain smart card reader
Também para HighSecLabs MDR102: Manual do utilizador (15 páginas)

Imprimir página
Secure Multi-Domain Smart Card Reader
Models:
RS20N-3 (MDR102) – Secure 2-Port Multi-Domain Smart Card Reader
RS40N-3 (MDR104) – Secure 4-Port Multi-Domain Smart Card Reader
Intended Audience
This document is targeted at the following professionals:
•
System Administrators.
•
IT Managers with adequate knowledge of PKI architecture.
Objectives
This document describes the fundamental configuration procedures that
are required to install the HSL Multi-Domain Smart Card Reader.
Prerequisites
•
Obtain and install the applications, drivers and files of the cryptographic
software (CSP) which corresponds to your selected smart card vendor.
•
Obtain a smartcard from your selected smart card vendor.
•
Verify that your smart card setup works correctly on each PC using a
standard smart card reader prior to connecting the MDR.
Initial MDR Configuration Steps
Table 01 describes the initial MDR configuration steps
#
Action
Install Smart Card
1
Applications
2
Turn PC ON
Test Smart Card using a
3
Standard Reader
4
Connect MDR to Power
Connect USB Cables
5
to PCs
Insert Smart Card into
6
the MDR
Initial Association with
7
PC#1
Initial Association with
8
PC#2
Action Description
Verify that the applications, drivers and files of the cryptographic
software (CSP) that corresponds to your selected smart card vendor are
installed on all the computers that you plan to connect to the MDR.
Note: Perform a computer restart in case needed to complete the smart
card application installation.
Make sure that all the PCs are turned ON.
Verify that your smart card setup works correctly on each PC using a
standard smart card reader prior to connecting the MDR.
Connect the MDR to Power
Connect the MDR USB cables to the computers. Cable numbers
correspond to the numbered MDR buttons.
Insert your smart card into the MDR reader socket.
Note: Make sure the smart card chip is facing towards you.
Press PC Number Button#1 to initialize the MDR on PC#1.
Press PC Number Button#2 to initialize the MDR on PC#2.
Notes: Repeat the process on the remaining PCs.
RS20N-3 (MDR102) • RS40N-3 (MDR104) | QUICK CONFIGURATION GUIDE
Hardware Terms
The following terms are used to describe
hardware elements in this document:
1. Numbered USB Cables: USB Cables with numbered connectors.
2. Card Reader Slot
3. PC Association Led
4. PC Number Button
5. PC Number Led
6. DIP Switch
2
3
4
5
1
6
Expected Behavior
1 second beep sound.
All LED lights blink once.
All PC Number LED lights blink constantly.
1 second beep sound.
All lights are OFF.
PC Number Button#1 light turns ON.
The MDR appears as a smart card reader
under PC#1 device manager.
PC Number Button#1 light turns OFF.
PC Number Button#2 light turns ON.
The MDR appears as a smart card reader
under PC#2 device manager.