Gallo Tech GStarter I Manual de operação e instalação - Página 10

Procurar online ou descarregar pdf Manual de operação e instalação para Arrancador remoto Gallo Tech GStarter I. Gallo Tech GStarter I 12 páginas. Push button start & alarm system with 2 remote key fobs

Imprimir página

Installing Connector C3:

Circuit)

Note: connect C3: Red, C3: Pink and C3: BLACK wires for stand alone "Engine Start" only configuration.

Connect all wires when installing "Engine Start with Alarm" configuration. See Fig. 8.

C3: RED fused wire – + 12v Constant Battery Input (Module Supply Power). This connection should always

have +12v available (BAT terminal on ignition switch or equivalent). Solder connect the RED wire.

C3: YELLOW – Parking Light +12v output. 3Amps max. Solder connect one of the YELLOW wires to the

vehicle's parking light relay. If parking lights require more than 3 amps use an external 10 Amp relay.

C3: ORANGE – Siren +12v Output. Connect to the RED Siren input wire. Connect the second siren input (BLACK

wire) to a good chassis ground.

C3: PINK – Ignition ON +12v Input for Active Arm Lock/unlock trigger. Connect to IGN 1 on ignition switch.

(+12v in ON and START position and 0 v in OFF and ACC position.)

C3: BLACK/WHITE – Neg. (-) Door Trigger switch Input. Connect the BLACK/WHITE wire to the Neg. (-) Door

Trigger switch. If vehicle has "+" Pos Door Trigger input use an external relay as shown in Fig. 8.

C3: GRAY/RED - +12v Foot Brake Switch Input Used for Active Arm door lock input. Connect to Foot brake

switch terminal that has +12v only when foot brake is depressed.

C3: BLACK – Neg. (-) Ground Connection

Connect the BLACK wire to a good chassis ground in a convenient location.

Gallo

Figure 6

Figure 7

7 Pin Wire Harness

- 10 -

(Parking Lights, Siren, Foot Brake and Door Trigger

52008