Dynex DX-CR312 Perguntas mais frequentes - Página 3

Procurar online ou descarregar pdf Perguntas mais frequentes para Adaptador Dynex DX-CR312. Dynex DX-CR312 5 páginas. Lecteur de carte mémoire 20-en-1
Também para Dynex DX-CR312: Manual (6 páginas), Manual do utilizador (13 páginas), Manual de configuração rápida (2 páginas), (Inglês) Manual do utilizador (13 páginas), (Francês) Manual De L'utilisateur (13 páginas)

Question 5: I receive an error message when I install the card reader software on my

Windows PC.

Make sure the card reader is connected to your computer. Unplug and reconnect your

USB cable.

Make sure that this is the only card reader connected to your computer. If other card

readers are connected, unplug them before installing the software.

Question 6: How do I remove my memory card once I have finished working with the

files?

Caution: Do not insert or remove memory cards while the green LED is flashing. Doing so

may cause damage to your card or loss of data.

Windows:

1. Right click the memory card drive in My Computer/Computer, then click Eject.

2. Remove the memory card.

Mac:

1. Click and drag the disk icon to the Eject icon.

2. Remove the memory card. The green LED turns off.

1. Click the memory card icon on the desktop and select Eject.

2. Remove the memory card. The green LED turns off.

Drivers Questions

Question 7: Where can I find the drivers for this card reader?

The card reader is a plug-and-play device and uses drivers already on your computer.

Hardware Questions

Question 8: I receive an error message when I try to access my memory card or try to

save to it.

Make sure that your memory card is fully inserted into the slot on the card reader.

Some memory cards have a read/write security switch that may be set to ON/OFF or

Locked/Unlocked. Make sure that the security switch is set to Write

Enabled/ON/Unlocked.

Make sure that the amount of data you attempted to store has not exceeded the capacity

of the card.

Inspect the end of the memory card for dirt or material closing a hole. Clean the contacts

with a lint-free cloth and small amounts of rubbing alcohol.

Try a different memory card of the same type in the same slot. If a different memory card

works, the original memory card should be replaced.

Some memory cards are not compatible with Windows XP such as SDHC and SDXC. If

you are using Windows XP and a SDXC memory card see

Your card may not be in the correct format. See

format your memory card.

If errors persist, replace the memory card.

The green LED turns off.

Question 10

Question 9

below for steps on how to

on page 4.