Agrox RTU5015 Manual do utilizador - Página 9

Procurar online ou descarregar pdf Manual do utilizador para Controlador Agrox RTU5015. Agrox RTU5015 12 páginas. Gsm gate opener remote switch

connect the input and GND point to make it as Normal Close.

pwd#KEYNO#

Modify the digital input type as NO; if the sensor you used with this unit is NO, then you should set the unit

as NO type. The default is NO.

6.12 Check GSM signal quality

pwd#CSQ?

Check GSM signal quality. This command is useful to see the GSM network signal level of your GSM Gate

Opener is receiving. After you send the command, you can receive a SMS with signal quality in range 0 to

32 (if it is 0 we doubt it will ever answer). You should have a signal above 12 to be sure of being able to

open the gate in any condition. Better if above 16. You should add an external GSM antenna if this is not

the case, or eventually even change operator with another that serves your area better.

6.13 Enable return SMS confirmation when Relay action

pwd#R#

Tips:

if you enable it, when the relay action, close or open, the unit will return a SMS confirmation to you.

The return SMS is:

The relay is ON

pwd#N#. Default is no return SMS confirmation when relay action. This is very useful when you use the

RTU5015 to control the equipments remotely.

To check the settings, you can use the command:

Relay action return SMS OFF

6.14 Modify the Alarm SMS message when inputs triggered

The user can modify the digital inputs alarm SMS message by the following command; the SMS Alert

message should less than 30 letters. When the sensor triggered, these SMS message will send to the

Position 1 and Position 2 cell phone numbers to alert the user. The default SMS Alert message is: Door

Open Alarm!

pwd##TEXT1xxxxxxxxxxxxx#

The above command is use to modify the digital input 2 alarm SMS text message.

pwd##TEXT2xxxxxxxxxxxxx#

The above command is use to modify the digital input 1 alarm SMS text message.

E.g.: Modify the digital input1 alarm SMS Text message as Left Windows Open! If the password is 1234,

then you can send

1234##TEXT2Left Windows Alarm!#

Tips:

1. This command includes two ##;

2. The xxxxxxxx in this command is indicates the message contents;

3. The TEXT1 is part of the command; refer to the input 2 message,not input 1 message;

4. The TEXT2 is part of the command, refer to the input1 message, not input 2 message.

7. Installation

The Relay is

pwd#M?

Page 9 of 9 Ver 1.3

OFF. You can disable it by the following command:

it will return:

Relay action return SMS ON

File No.:RTU501513