maidenhead aquatics Aquatropic LED Manual de início rápido - Página 2

Procurar online ou descarregar pdf Manual de início rápido para Equipamento de iluminação maidenhead aquatics Aquatropic LED. maidenhead aquatics Aquatropic LED 2 páginas.

Imprimir página
HOW TO INSTALL
YOUR AQUATROPIC LED
1.
The power supply transformer is
not waterproof – this must be
mounted such that it cannot fall
into the aquarium or be splashed
by water. The cable must be
installed with a drip loop to
prevent any water running down
the cable into the plug socket.
2.
Three options for fitting the Aquatropic LED
a.
Hood location with adhesive pads – Push fit the
brackets onto the lighting unit – see illustration on
pack, attach the double- sided adhesive pads to the
flat surface of the brackets. Fix the Aquatropic LED to
the underside of the hood in the desired location –
ensure the hood surface is flat, clean and dry. DO
NOT attach directly to fluorescent lamps or lamp
reflectors.
b.
Hood location with screws - Ensure the hood
material is thicker than the length of the screws to
prevent them protruding through the outer surface.
Fit the brackets onto the lighting system – see
illustration on pack. Place the Aquatropic LED in the
desired location under the hood and draw around
the brackets with a pencil to indicate their position.
Remove the brackets from the Aquatropic LED and
place them in the pencil marked position in the hood.
Using the self-tapping screws provided fix the bracket
in position using the fixing holes in the bracket. When
both brackets are fixed in position push fit the
Aquatropic LED into the bracket.
c.
Hood location with glue – (glue sold separately)
push fit the brackets onto the Aquatropic LED – see
illustration on pack.
Select desired location on the underside of the
aquarium hood and mark the position of the brackets.
Keep the hood away from the aquarium while gluing
the brackets as the glue can be dangerous to the fish.
Clean the marked area with a damp cloth then allow
to dry, remove brackets from the LED unit and glue
into the marked position on the aquarium hood.
An all-round plastic / wood glue is recommended
for application, for example: 502 super adhesive
glue. Always follow the glue manufacturer's
instructions fully.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
RETRO FIT
BRACKETS
RECOMMENDED
INSTALLATION
SWITCH
INSTRUCTIONS
ALL LEDS OFF
(middle 0)
BLUE LEDS
ON (I)
BLUE & WHITE
LEDS ON (II)
Retro fit
screw position
Sucker
button slot