Galvo Shed GVO2315 Manual - Página 2

Procurar online ou descarregar pdf Manual para Armazenamento ao ar livre Galvo Shed GVO2315. Galvo Shed GVO2315 4 páginas. Sloping roof garden shed

Imprimir página

page 2 - GVO2315

Door Assembly

Parts needed:

Door sheet

Door sides

Door tops & Bottoms

door strap

hinges

Method:

Rivets are better for door assembly

1. Attach (j) door top & bottom to (d) door sheet @ centre ribs only

2. Attach (g) door sides to (d) sheet through (i) @ 4 corners

3. Attach (l) door strap in centre of door sheet slipping under (g) fixing

to sheet ribs and door sides

4. Attach hinges (o) approx 150mm from top and bottom of door

through (g) sides. Fixing should be centred on (g).

5. turn your door over and fix 4 corners thru all "U" channels.

Hanging the Door

Parts needed:

- The door you have just made

2 x narrow sheets

2 x "Z" door jambs

Method:

1. Attach (k) 1980mm "Z"s to narrow sheets (c) on the rib with

the narrow pan.

2. Lay the premade door face down on 1 of the narrow

sheets approx 30mm up from bottom and down from top

3. Check door is centralised on the sheet (top & Bottom). fix

hinges through side of "Z" door jamb (k).

Front wall assembly

Parts needed:

- The pre-hung door you have just completed and 1

padbolt

1 x narrow sheet with "Z" door jamb on it

2 x 2255mm "U" channels

2 x 793mm door spacers

Method:

1. Layout door with the sheet attached and the nar-

row sheet with "Z" attached as shown

2. Cap the sheets with (e) 2255 channels. Channels

will end short of sheeting 10 - 15mm. Higher side of

channel to inside.

3. Use (h) Door spacers to make sure door fits gap

OK (they sit on top of the "Z" jambs).

4. Drill & Fix (Rivet or screw) channels at every 2nd rib

down thru the top.

5. Attach door spacer at each end thru "Z" door

jambs and channels.

6. 4 fixings underneath thru channels into sheeting pan & top and bottom of (h) door

spacers & "Z"s

7. Fit the padbolt to door strap on the outside door using wide flange rivets supplied (or

screws).

If you choose to vary from these instructions your warranty will be impaired.

Drawings are diagrammatic and are not

necessarily to detail.