Dynojet PCV I25-028 Manual de instalação do utilizador - Página 2

Procurar online ou descarregar pdf Manual de instalação do utilizador para Unidade de controlo Dynojet PCV I25-028. Dynojet PCV I25-028 5 páginas. 2016 ski-doo 1200 snowmobile

Imprimir página

POWER COMMANDER V

INPUT ACCESSORY GUIDE

USB CONNECTION

EXPANSION PORTS 1 & 2

Optional Accessories such as

Color LCD unit or Auto tune kit.

PCV Wire Connections

1. Remove the rubber plug on the backside of the

unit and loosen the screw for the corresponding

input.

2. Using a 22-24 gauge wire, strip about 10mm

from its end.

3. Push the wire into the hole of the PCV until it

stops and then tighten the screw.

4. Make sure to reinstall the rubber plug.

Note: If you tin the wires with solder it will make

inserting them easier.

I25-028

www.powercommander.com

ACCESSORY INPUTS

Map-

Shifter-

Speed-

CRANK

ANALOG

SPEED

SHIFTER

MAP

Analog-

MAP

Crank-

The PCV has the ability to hold two different

base maps. You can switch on the fly between

these two base maps when you connect

a switch to the MAP inputs. You can use

any open/close type switch. The polarity of

the wires is not important. When using the

Autotune kit, one position will hold a base map

and the other position will let you activate the

learning mode. When the switch is "CLOSED"

Autotune will be activated.

Not used for snowmobiles.

If your application has a speed sensor then

you can tap into the signal side of the sensor

and run a wire into this input. This will allow

you to calculate gear position in the Control

Center Software. Once gear position is setup

you can alter your map based on gear position

and setup gear dependent kill times when

using a quickshifter.

This input is for a 0-5v signal such as

engine temp, boost, etc. Once this input

is established you can alter your fuel curve

based on this input in the control center

software.

Do NOT connect anything to this port unless

instructed to do so by Dynojet. It is used to

transfer crank trigger data from one module to

another.

2016 Ski-Doo 1200 PCV - 2