Gama Garden GLM 48P-1 Basic Manual de instruções - Página 15

Procurar online ou descarregar pdf Manual de instruções para Cortador de relva Gama Garden GLM 48P-1 Basic. Gama Garden GLM 48P-1 Basic 19 páginas.

Acquaer Kft.

15/19

www.gamagarden.eu

H-4900, Fehérgyarmat, Szatmári utca 11.

1.Installing and removing a battery

• Switch off the engine and all power consumers

• This battery may only be used on the place provided by the manufacturer.

• Avoid short circuits by tools.

• Remove the foreign body from the surface of the battery and firmly clamp the

battery after inserting it.

• Before installation: Clean the poles and terminals and grease them.

• When installing: clamp the positive pole and ensure that the pole terminals are

firmly seated.

2.Storage and transport

In unfilled condition, the batteries should be stored cool and dry. Batteries are to be

subjected to a full charge (see Charge the battery) before storage (for example

during the winter break). New battery has about 80% charge capacity.

3.Maintenance

Sealed batteries require no maintenance in the form of water refill, so do not open

the batteries again. Keep the terminal poles and the battery surface clean (damp

cloth, antistatic). Tighten the clamps and grease them lightly. Check the charge level

of the battery by voltage control and recharge if necessary (see 4.Charge the

battery).

4. Charge the battery

Important! For sealed batteries such as yours, the charge is carried out using the

supplied battery charger as shown in Following pictures. Table 1 in the case of a non-

original charger requires monitoring of the charging voltage as well as a manual

override. Observe the instructions of the charger manufacturer!

IMPORTANT:

• If the characteristic of a charger manufacturer is not known, check voltage

monitoring with one voltmeter and perform manual switch-off at 14.4V.

• The rated current of the charger should be 1/10 of the nominal capacity in

amperes.

• When charging, first connect the battery to the charger, then switch on the

charger.