Dea 202 E Instruções e avisos - Página 4

Procurar online ou descarregar pdf Instruções e avisos para Unidade de controlo Dea 202 E. Dea 202 E 7 páginas. Control board 230 v for gate automation operating

Imprimir página

Protection level

..............................................IP 54

6 OPERATING CONDITIONS

202E control board is designed for the automation of swing gates operated by 230 V a.c. motors.

This control board has been designed and tested for operation under "normal" conditions for both

residential and industrial use.

WARNING Using the product under unusual conditions not foreseen by manufacturer may cause

dangerous situations; this is the reason why all the conditions prescribed in these instructions must be

followed.

WARNING Under no circumstance must the product be used in an explosive environment or sur-

roundings that may prove corrosive and damage parts of the product.

ASSEMBLY AND WIRING INSTRUCTIONS

Connect to the power supply 230 V a.c.± 10% 50 Hz through a multi pole switch or a different device

that can ensure multi pole disconnection from the power supply, with a contact opening of 3 mm. Use a

cable with a minimum section of 3 x 1,5 mm² (e.g. a H07RN-F type).

1-2

Flashing light output 230 V a.c. 50 Hz max 40W

3-4

Motor output max 1 X 500W (5 = opens, 6 = closes, 7 = common)

5-6-7

Motor output max 2 x 500W (8 = opens, 9 = closes, 10 = common)

8-9-10

N.O. open/close switch.

START

N.C. Photocell input. When activated, it reverses the movement while closing, not

FOTO

active while opening.

Common inputs

COM

14-15

Auxiliary power supply output 24 V a.c. max 400mA

Aerial signal

Aerial ground

8 USE INSTRUCTIONS

After making all correct connections to the terminal board, feed the control board and remember to short-

circuit the FOTO input, if unused, with the common (COM).

Factory settlements allow the use of standard system without any installer's programming support. If ne-

cessary, operation parameters may be personalized.

SEL and SET switches and signalling led allow control board settlements and programming. All program-

ming functions may be done at control board ignition or after a closing cycle.

8.1 433 Mhz built in receiver

Radio control learning:

1. Press repeatedly the "SEL" key to turn the RADIO led on.

2. Press (once) the "SET" key: the RADIO led starts flashing and shows the receiver learning status.

3. Press the radio control key you want to settle. The led lights up for a second, then starts flashing (lear-

ned key).

4. For any other key or radio control, repeat step 3.

5. Wait for the led to light up (learning complete). At this point press on the "SEL" key to select any other

Operating instructions and warnings

Table 1 terminal boards connection

2 0 2 E