Jade GIGALINK GLR2701 Instruções

Procurar online ou descarregar pdf Instruções para Recetor Jade GIGALINK GLR2701. Jade GIGALINK GLR2701 2 páginas.

GLR2701/GLR43301 GIGALINK™ RECEIVER SETUP INSTRUCTIONS

Single Code Programming

Single code programming can be achieved by following the steps below:

Step 1:

Connect power to the GIGALINK™ receiver. Make sure all switches on the mode dipswitch

are off.

Step 2:

Momentarily short the two CC pins on the receiver board. (This sets all the channels to a

random code. If there are transmitters previously programmed, they will have to be re-

programmed when CC pins are shorted.)

Step 3:

Connect the transmitter to the receiver by inserting the GIGALINK™ cable into the transmitter

and receiver 2.5-mm socket. (This will activate the programming mode and is indicated by the

red light (LED) on the transmitter that must remain "on")

Step 4:

Activate one of the selected channels on the transmitter for approximately one second, LED

should blink twice to confirm code programming and then switch "off".

Step 5:

Disconnect GIGALINK™ cable.

Repeat steps 3 to 5 to program another transmitter channel.

Mode Setting

The 4-way dip switch functions as a mode selector for the relay. User should set the receiver mode correctly.

See below table for different mode setting.

The output relay will respond in the following manner when receiving the correct

GLR2701/GLR43301 Mode Settings

DIP Switch Mode Settings

signal from a transmitter

"Momentary": Relay on, only while correct signal is received

"Flip-Flop": Relay alternates at every correct incoming signal

"Delayed Off 1": Relay on, but delayed off for 1-10 seconds, adjustable

by trimpot

"Delayed Off 2": Relay on, but delayed off for 10-300 seconds,

adjustable by trimpot

"Pulsing": Relay will pulse at 1Hz for 10-300 seconds, adjustable by

trimpot

"Latching On": Relay will energize until supply to receiver is

momentarily interrupted

ELSEMA

Enter the world of wireless