aireRyder FN433 series Manual de instruções de instalação e utilização - Página 4
Procurar online ou descarregar pdf Manual de instruções de instalação e utilização para Ventilador aireRyder FN433 series. aireRyder FN433 series 6 páginas. Ceiling fan model classic
Imprimir páginaINSTALLATION WITH REMOTE CONTROL (AVAILABLE AS OPTION)
Start with steps 1-2 of the above
fan installation illustration
(without remote control).
5. Connect wires from supply and
bracket to the wiring terminals as
follows:
Brown wire
Blue wire
Green/yellow striped wire
IMPORTANT: In order for the remote control to function properly, make sure to set the pull chains to:
HIGH position for the fan speed.
-
ON position for the fan light.
-
OPERATING THE FAN
Check the fan before switching it on!
Risk of injury: The fan can only be operated if no defects have been found upon inspection.
In case a part is defective, it will have to be replaced before using the fan.
Risk of injury: Before changing the fan rotating direction, the fan has to be switched off and
come to a complete stop.
Check that the fan is in safe operating condition:
Check to make sure that there are no visible defects.
-
Verify that all parts are properly installed and fastened.
-
Operating the fan and the fan light
The fan can be operated at different speeds by pulling the three-speed switch using the pull cord:
First pull: HIGH speed
-
Second pull: MEDIUM speed
-
Third pull: LOW speed
-
Fourth pull: OFF
-
The fan light can be controlled by pulling the on-off switch using the pull cord:
First pull: ON
-
Second pull: OFF
-
3. Install the remote control
receiver in the bracket as
shown. Make sure that you
do not trap any wires.
6. Stick the infra-red receiver
kit on the ceiling and leave it
outside of the canopy.
4. Connect the pair of 4-way
male/female connectors from the
bracket to the remote control
receiver and connect the pair of
4-way male/female connectors
from the remote control receiver
to the fan.
Follow the steps 5 to 8 and 10
of the above installation
instructions.
Skip step 9 of the above
installation instructions, as the
pull cords are not necessary
for the use with remote
control.
4