HIKOKI DH50SA1 Manual de Instruções de Manuseamento - Página 11
Procurar online ou descarregar pdf Manual de Instruções de Manuseamento para Perfurar HIKOKI DH50SA1. HIKOKI DH50SA1 18 páginas.
Imprimir páginaPRECAUTIONS ON USING HAMMER DRILL
Wear earplugs to protect your ears during operation.
Do not touch the bit during or immediately after
operation. The bit becomes very hot during operation
and could cause serious burns.
SPECIFICATIONS
Voltage (by areas)*
Input*
Capacity
No load speed
Full-load impact rate
Weight (without cord, side handle)
* Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Case ........................................................................... 1
I type: Side handle ...................... 1
(2) Side handle
II type: Bar type handle ............... 1
Either type I or type II Side handle is attached.
(3) Stopper (I type Side handle only) ....................... 1
(4) Dust cover ................................................................. 1
(5) Hexagon bar wrench ............................................... 1
(6) Hammer grease A ................................................... 1
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES (sold separately)
Through-hole drilling:
(1) Drill bit (hexagon shank)
Total length: 420, 570 mm
External dia.: 16, 18, 20, 22, 25, 28, 30, 32, 35, 38,
40, 44, 50 mm
Anchor hole drilling:
(3) Cotter
(1) K-Taper shank adapter
D type handle .................. 1
(2) A-Taper
sleeve
Before starting to break, chip or drill into a wall,
floor or ceiling, thoroughly confirm that such items
as electric cables or conduits are not buried inside.
Always hold the body handle and side handle of
the power tool firmly. Otherwise the counterforce
produced may result in inaccurate and even
dangerous operation.
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
1140W
Drill bit: 50 mm
Core bit: 125 mm
300/min.
2450/min.
9.8 kg
Large-dia. hole boring:
(1) Center Pin
(Guide
plate)
(1) Center pin
Applied to core bits from 50 mm to 125 mm.
(2) Core bit
External dia.: 50, 65, 80, 90, 100, 125 mm
(3) Core bit shank
Crushing:
(1) Cold chisel
Total length: 300, 380, 450 mm
Groove digging and edging:
(1) Cold chisel
Total length: 300, 380, 450 mm
Asphalt cutting:
(1) Cutter
Width: 50, 75 mm
Total length: 400 mm
Syringe (for chip removal):
Hammer grease A:
500 g (in a can)
30 g (in a green tube)
Optional accessories are subject to change without notice.
English
(2) Core
(3) Core bit
bit
shank
10