Jadever JC-600 Manual do utilizador - Página 3

Procurar online ou descarregar pdf Manual do utilizador para Balanças Jadever JC-600. Jadever JC-600 4 páginas. Crane scale

seconds it will turn back to zero and ready for operation

Note: It is recommended to allow scale 3-5min of warm-up time before starting weighing

operation.

6-2 Zero

Press ZERO to zero the display

6-3 Weighing

Begin with no load on the scale, the display reading zero. Place item(s) to be weighted on the

scale. The display will show the weight

6-4 Tare

Under the weighing mode, place the container on the scale. Press ZERO to tare.

6-5 Battery recharge

The charge lamp turns green from red when the recharging is completed

 When the battery indicator is flashing, it means the low battery. Please recharge. However,

the scale can continue to operate for about 5hours without recharge

 After the battery indicator is on for several hours without recharge or there is no more power

in the battery, the scale will be powered off automatically.

 After recharge, the screen still cannot display, it indicates that either there is difficulty in

battery recharging or a damaged battery. Please contact the service person.

7. Calibration procedure

Note: make sure the standard the weights are available when doing calibration

1. Press ZERO when power on the crane scale, while "SPEN" is displayed on the screen

2. Press ZERO to enter the calibration，while "00000" is displayed on the screen

3. Press HOLD to choose the weighing value, press SWITCH to move the decimal point

Note: It is better to choose the value which is close to the max capacity.

4. Put on the corresponding weight

5. Press ZERO to save

8. Setting mode

1. Press SWITCH when power on the crane, while "

2. Press HOLD or SWITCH to shift the sound modes.

0= no sound

3. Press ZERO to move to hold function setting mode, while "

4. Press HOLD or SWITCH to shift the hold modes.

0= no hold function

5. Press ZERO to move to zero function setting mode, while "

1= with sound

1=with hold function

" is displayed on the screen