JADO 818/712 Series Instruções de instalação - Página 2
Procurar online ou descarregar pdf Instruções de instalação para Produto de canalização JADO 818/712 Series. JADO 818/712 Series 4 páginas. 3/4" thermostatic mixing valve trim kit
Imprimir página
RECOMMENDED TOOLS
ROUGHING-IN DIMENSIONS
For reference
32" TO 42"
FOR BATH/SHOWER
AND BATH FILLER
(OPTIONAL)
(813mm TO 1067mm)
1
TEMPERATURE CALIBRATION
Unscrew PLASTER GUARD SCREWS and remove PLASTER GUARD.
Check that arrow marking B points vertically upwards. If not, push
the BLACK CLAMP on the SECURING RING to the right, pull off KNOB
MOUNT and reinstall KNOB MOUNT with arrow "B" pointing upwards.
The maximum mixed water temperature is set at 109° F at the
factory. This setting can be changed if desired.
Remove the TEMPERATURE LIMIT STOP (H shaped Black Plastic
part). Re-install it at the desired notch as indicated in the diagram
to limit the maximum mixed water temperature to 104°F or 112°F.
For 100° F adjustment, turn the water supply on. Turn KNOB
MOUNT until the spout temperature is 100° F. Check that arrow
marking A on the KNOB MOUNT still points upward after adjusting
the thermostat to 100° F. If not, pull out the RED LOCKING DEVICE.
Remove KNOB MOUNT by pulling it towards you while standing directly
in front of the valve.
Reinstall the KNOB MOUNT so that the arrow marking A points upwards.
Reinstall RED LOCKING DEVICE.
Phillips Screwdriver
7-3/16"
(182.5mm)
5-7/8"
(149mm)
3/4" NPT INLETS
(19 mm)
Regular Screwdriver
3-3/8"
(86mm)
48" TO 54"
FOR SHOWER ONLY
(OPTIONAL)
(1219mm TO 1372mm)
FINISHED
FLOOR
TEMPERATURE
LIMIT STOP
SECURING
RED LOCKING
3/4" NPT OUTLETS
(19mm)
C L
1-11/16"
TO
2-1/2"
(42mm TO
64mm)
ARROW
"B"
104°
109°
112°
RING
DEVICE
FINISHED
WALL
BLACK
CLAMP
ARROW
"A"
KNOB
MOUNT
H 9 6 5 2 1 6 C