Adeunis RF TWIMO ARF7581AA Manual do utilizador - Página 14
Procurar online ou descarregar pdf Manual do utilizador para Unidade de controlo Adeunis RF TWIMO ARF7581AA. Adeunis RF TWIMO ARF7581AA 16 páginas. Rf modules starter kit
Imprimir páginaRSSI -88dBm
Max -52dBm : higher RSSI level seen by the Starter kit
Average -87dBm : average RSSI level in the selected channel
Min -98dBm : lower RSSI level seen by the Starter kit
On the right side a bargraph shows the three RSSi levels (max,
Average, Min) as well as a real time measured RSSI (yellow pod).
Note : by using the «pause» box, the Max and Min RSSI levels
are reinitialized.
6.4.
USB mode
The USB mode allows to connect the Extension board to a PC. It's
mainly used for Data Loggin.
•
From the Home Screen, clic on the «USB» icon
•
Connect the USB socket located on the target board (don't
use the one from the Open4 platform) to a PC
•
Check that the correct drivers are installed.
•
Clic on «Reset» icon if you need to reset the module.
•
Clic on «Cmd Enter» to enter command mode.
•
The Open4 platform is now acting as a virtual port com (direct
access to the TWIMO module at 115.2kbps) and any type of
Terminal can be used.
•
To exit the «USB» mode, clic on the «Back» icon.
6.5.
Running screen
When the evaluation is launched the Starter kit is showing a screen which displays the received frames. The
frames can be display as Ascii or hexadecimal.
6.6.
General notes
When the evaluation is launched, the LCD screen automaticaly turns 180°, meaning that the Starter kit must be
handled with the antenna facing the top to maximize the performances.
Each of the three Test modes (TX/RX, Received level and Scanner) are offering a «debug» function located on
the «Run» screen. Select this function to check the configuration exchange through the UART.
208474A_UG_Starter kit_TWIMO_V1.0
: latest RSSI level measured
14