GAME 4515 Manual do Proprietário - Página 4

Procurar online ou descarregar pdf Manual do Proprietário para Filtro de piscina GAME 4515. GAME 4515 8 páginas. Pool filter system

Assembly Instructions:

1. Open the filter tank by removing retaining ring and remove all parts.

2. Fill sand chamber with sand (See figure 2)

Water Chamber

Separator Plate

Note: The tank should be in its permanent location before filling the chamber with sand. Otherwise, the

unit will be heavy and difficult to move around.

a. Check to ensure that the bottom strainer is correctly positioned.

b. Check to ensure that the tank separator plate is seated properly.

c. Fill the sand chamber half full with water.

Caution: Use breathing filter/mask approved for dust and sand and adequate eye protection while

filling the tank. Avoid breathing dust.

Important: To prevent damage to the container and the bottom strainer, fill the tank halfway with

water before adding the filter sand.

d. Pour 26 lb of Number 20 silica sand into the sand filter chamber being careful not to allow any

sand to enter the filtered water chamber.

3. Attach tank cover and lock into place using retaining ring. Ensure the main tank seal around the top of

the filter tank is in good condition and securely seated in the groove. Be sure it is free of sand.

a. Carefully place the tank cover onto the filter tank. The tank cover should be oriented so that

the notch on the cover is aligned with the matching tab on the filter tank – this ensures proper

alignment.

b. When tight, the gap between the clamp halves at the tightening screw should be

approximately 1/16" to 1/4". (See figure 3)

1/16" to 1/4" Gap

Figure 2

Figure 3

Sand Chamber

Base Strainer