Maintronic XRD600 REG Manual - Página 15

Procurar online ou descarregar pdf Manual para Equipamento de iluminação Maintronic XRD600 REG. Maintronic XRD600 REG 18 páginas. Dmx-retrofit-dimmer

8.3 DMX parameters

Some system parameters can be programmed

via DMX telegrams. In this case, a separate DMX

address is used for each parameter. The addresses

have the same values as the parameter IDs (1 - 7).

The appropriate parameter selection during pro-

gramming determines which parameter should be

programmed.

NOTE - Programming must be done within

the first 60min after power-on.

www.maintronic.de

1. Press the device button > 2 seconds ... (load

jumps to 0 and 100% for half a second each),

then the LED flashes consistently.

2. Select the desired parameter by pressing the

button again. Again a parameter change is in-

dicated by the output level 0 and 100% (as at

start). The flashing pattern is then indicated by

a long light followed by a brief flash of the LED.

3. Set the fader of the desired parameter:

4. To save, press the device button > 1 second ...

(load jumps to 100%, 7%, 100% for half a sec-

ond each), then the LED flashes consistently.

NOTE - If the programming does not take

place after 10 minutes, the programming

mode will be exited and the device is back

in normal operation.