Core 40062-1 Manual de início rápido
Procurar online ou descarregar pdf Manual de início rápido para Tenda Core 40062-1. Core 40062-1 2 páginas. 9 person lighted instant cabin tent - 14 x 9
Imprimir página
9 PERSON LIGHTED INSTANT CABIN TENT - 14 x 9
Two people can easily setup this instant tent in 60 seconds or less.
Contents & Repair Parts:
Center Hub #90491
LED Roof Pole #91881
Side Eave Pole
Side Hub #90138
#91242
Corner Joint
#91150
Corner Telescoping
Leg Pole
#91241
Mid Eave Pole
Mid Telescoping Leg Pole
#91240
#91241
1
Prepare for Setup
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to set up your tent.
• Remove all contents from bag.
• Unfold (6) leg poles from the pod shape. Unfold legs again at
joints, to lay tent at. Center will stand up.
2
Lift Roof and Eave Poles
NOTE: 2 people will be needed to erect and extend the tent poles.
•
Lift up on corner joints until eave poles at 3-way side hubs are extended.
• Grab roof poles and pull straight out to create tent's cabin shape
(leg poles will angle at joints to partially stand up).
3
Extend Leg Poles
NOTE: DO NOT extend telescoping
poles until all legs and ceiling hubs are
elevated.
• Extend each of the (6) leg poles until
the locking buttons "click," and lock
Not Pictured:
the poles into place.
Awning Pole #91181
Carry Bag #91182
Rain y #91183
4
Re ective Guyline
#91221
•
Battery Compartment
•
#91225
the upper portion of the button box on leg pole labeled RAINFLY.
(Detail 1)
•
(Detail 2)
• Insert metal end of awning pole into hole on plastic grommet located
at each side of door. (Detail 3)
• T
•
each pole. (Detail 4)
1
LED ROOF POLE
5
Stake Tent, Secure Ground
Vents and Guylines
LEG POLE
• Drive stakes at a 45º angle
through web loop at base of
tent to secure to ground.
(Detail 5)
• Floor of tent should be taut when staked properly.
STITCH LINE
LOCKING
BUTTON
"CORE" logo over door.
3
2
RAINFLY
SLEEVE
PLASTIC
GROMMET
5
Stake Tent, Secure Ground Vents and Guylines
5
(continued)
•
• Stake out each guyline at a 45 degree angle.
• Tighten guylines as needed by adjusting the slider up the cord.
• Stake out ground vents on either side of tent (where air intake
graphics are).
Install Room Divider
6
NOTE: The divider curtain provides extra privacy in
your tent.
• To install it, attach divider's plastic toggles to corre-
sponding loops on the wall inside the tent. (Detail 7)
Lighting Component:
NOTE: Pressing the "NIGHT LIGHT" button activates
amber-colored lights to help preserve night vision
OPTION 1
4
Add 4-D batteries to
Slide battery pack into
empty battery pack.
pocket located inside
(Batteries not included)
the tent.
OPTION 2
Rechargeable
Slide Power Pack into
Portable Power
pocket located inside
Pack
(not included)
the tent.
6
For optimized performance, use a Rechargeable Portable Power Pack
with a 5V, 1A output.
CAUTION: USB is not compatible with charging external device.
IMPORTANT: Remove battery pack before taking down tent. Failure to do so will
drain the batteries and possibly damage the tent fabric.
Model No. 40062-1
(Detail 6)
y.
7
Press buttons
on switch box
located on
either inside
or outside of
tent to turn on
Zip up pouch, then plug
lighting.
in battery pack cord
into lighting connector.
Press buttons
on switch box
located on
either inside
or outside of
tent to turn on
Zip up pouch, then plug
lighting.
lighting connector into
port on Power Pack.
(continued on other side)