HIKOKI WR 16SE Manual de Instruções de Manuseamento - Página 14
Procurar online ou descarregar pdf Manual de Instruções de Manuseamento para Chave de impacto HIKOKI WR 16SE. HIKOKI WR 16SE 20 páginas.
Imprimir página
English
PRIOR TO OPERATION
1.
Power source
Ensure that the power source to be utilized conforms to the power requirements specifi ed
on the product nameplate.
2.
Power switch
Ensure that the power switch is in the OFF position. If the plug is connected to a receptacle
while the power switch is in the ON position, the power tool will start operating immediately,
which could cause a serious accident.
3.
Extension cord
When the work area is removed from the power source, use an extension cord of suffi cient
thickness and rated capacity. The extension cord should be kept as short as practicable.
4.
Check the receptacle
If the receptacle only loosely accepts the plug, the receptacle must be repaired.
Contact a licensed electrician to make appropriate repairs.
If such a faulty receptacle is used, it may cause overheating, resulting in a serious hazard.
5.
Confi rming condition of the environment
Confi rm that the work site is placed under appropriate conditions conforming to prescribed
precautions.
MOUNTING AND OPERATION
CAUTION
To prevent accidents, make sure to turn the
switch off and disconnect the plug from the
receptacle.
1.
Mounting the socket
(1)
Slide the ring out of the groove, and insert the socket
so that the hole in the anvil aligns with the hole in the
socket. (Fig. 1)
(2)
Pass the pin through the holes.
(Fig. 2)
(3)
While making sure that the pin
doesn't fall, put the ring into the
groove. (Fig. 3)
2.
Switch operation (Fig. 4)
The switch in this machine
functions as a motor switch and rotational direction
selector switch. When the switch is set to R indicated
on the handle cover, the motor rotates clockwise to
tighten the bolt.
When the switch is set to L, the motor rotates
counterclockwise to loosen the bolt. When the switch
is released, the motor stops.
Socket hole
Ring
Pin
Fig. 2
14
Anvil hole
Fig. 1
Fig. 3
Switch
Fig. 4