Jaeger-leCoultre Master Compressor Diving Alarm Navy Seals Manual do utilizador - Página 3
Procurar online ou descarregar pdf Manual do utilizador para Ver Jaeger-leCoultre Master Compressor Diving Alarm Navy Seals. Jaeger-leCoultre Master Compressor Diving Alarm Navy Seals 6 páginas.
Imprimir página
Operating indicator
The seconds hand completes one revolution in 60 seconds.
This also shows you that the watch is running.
Setting the date
Pull crown A out to position 2. This timepiece features a date
display window at 3 o'clock and a rapid correction system.
If you have to move the date one day forward, turn crown
A (in position 2) clockwise. Repeat the operation until the
desired date is displayed. For months of less than 31 days,
follow the same procedure to move on to the 1st of the
month. When the operation is completed, push crown A back
into position 1.
After setting the date, move the hands forward to the desired
time - via 12 o'clock if it is after noon. When the operation is
completed, turn the compression key to the "closed" position
in the direction of the arrows.
Setting the alarm
Winding
Turn the compression key to the "open" position in the
direction of the arrow. Crown A will then be in position 1.
The alarm is wound by turning the crown clockwise. When
winding is complete, the crown is locked.
Setting the alarm time
Pull crown A out to position 2. This function enables you
to adjust the alarm's mobile disc by turning the crown
anti-clockwise, to position the triangular mark situated in
the centre of the dial over the desired chime time. When
the operation is completed, push crown A back into
position 1.
Switching the alarm on or off
The alarm is activated when crown A is in position 1. It is
stopped when the crown is in position 2. Therefore the
chime can be stopped at any time by pulling out crown
A. However, note that the crown must be pushed back
into position 1 to ensure water-resistance. When the
operation is completed, turn the compression key to the
"closed" position in the direction of the arrows.
Diving bezel
The Master Compressor Diving Alarm Navy SEALs watch
model features a unidirectional rotating bezel (can only
be turned anti-clockwise), with an index marking every
minute.
It can measure a particular time using the luminescent
white triangular marker as a reference point in relation to
the hour hand or minute hand.
To move the diving bezel, you need only grip it with two
fingers and turn it anti-clockwise to the desired position.
M
C
D
a
n
seal
aster
oMpressor
iving
larM
avy
- English
s
Adjusting the wristlet
Note: The wristlet illustrations below may not correspond to
either your wristlet or your watch, but the demonstration
illustrated is completely identical and valid.
Adjusting the clasp
The clasp on metal bracelets and articulated rubber straps is
fitted with an adjustment system enabling you to lengthen or
shorten your wristlet by 4 mm on either side, for greater wearer
comfort.
Using the fine adjustment system
Switch from the long position to the short position:
Remove your watch. Hold your clasp open between the thumb
and forefinger of one hand, with the wristlet section in your
other hand (fig. 1).
Fig. 1
Lift up the clasp cover so
as to release the hinged
part of the wristlet section
from its groove (fig. 2).
Fig. 2 Long position
Push down the hinged
part of your wristlet sec-
tion and place it in its
groove, facing the oppo-
site way to its initial posi-
tion (fig. 3).
Fig. 3 Shortened position
The switch from the short
to the long position is
made in the same way, but
in the opposite direction
(fig. 4).
Fig. 4 Extended position
3/6