Game ready 573197 Manual rápido - Página 2
Procurar online ou descarregar pdf Manual rápido para Bateria Game ready 573197. Game ready 573197 2 páginas. Rechargeable battery pack kit
Imprimir páginaPrior to Use
Prior to first time use, the Battery Pack must be fully charged per the instructions below!
Charging the Battery Pack
Insert barrel plug
DC Port
Charging:
Step 1) Insert the barrel plug end of the AC Charger into the DC Port located on the Battery Pack.
Step 2) Insert the wall plug into an AC wall outlet.
PLEASE NOTE: The AC Charger will display a red light during the charge cycle. Once the light changes
to green, the Battery Pack is completely charged and ready to use.
Step 3) Disconnect the barrel plug from Battery Pack, it is now ready to use.
Recharge Time:
The Battery Pack will require approximately 4-5 hours to fully charge, or less time for a partially charged Battery
Pack.
Checking the Power Level
Battery Pack
fuel gauge
button
Page 2
573197 - Rechargeable Battery Pack Kit
Plug into AC wall outlet
Light = Red (during charge)
Light = Green (charge complete)
IMPORTANT- Activate the LED lights by
pressing and holding the fuel gauge button
for 20 seconds.
Step 1 -
Press the fuel gauge button to display LED lights.
Step 2
Verify power level by viewing LED Light Indication chart
on page 3 of this Use Guide.
LED Light Indication
Power Meter -
Press the fuel gauge button to confirm the remaining power available on the Battery
Pack as shown:
fuel gauge
button
4 Green LEDs = 75 - 100% power remaining
3 Green LEDs = 50 - 75% power remaining
2 Green LEDs = 25 - 50% power remaining
1 Green LED = Less than 20% power remaining
The flashing red LED light indicates low power, the Battery Pack
needs to be recharged.
Using the Battery Pack
Control
Unit
Connect barrel plug
to Control Unit
Battery Connector Cable
Connect barrel
plug to Battery
Pack
573197 - Rechargeable Battery Pack Kit
Step 1
After the Battery Pack has been charged, take the
Battery Connector Cable and gently press the barrel
plug (marked on cable) into the DC port on the
Battery Pack.
Step 2
Plug the other barrel plug in the Game Ready
Control Unit. (As shown) The Control Unit is now
ready for approximately seven hours of treatment
time.
Step 3
Unplug the Connector Cable from the Game Ready
Control Unit immediately after each use to prevent
battery drain and to preserve the battery integrity.
Page 3