Maiwe MIGE1203 Series Manual do utilizador - Página 15
Procurar online ou descarregar pdf Manual do utilizador para Hardware de rede Maiwe MIGE1203 Series. Maiwe MIGE1203 Series 20 páginas. Industrial gigabit media converter industrial ethernet switch
MIGE1203 Series Industrial Gigabit Media Converter/MIGE2205G Series
Industrial Ethernet Switch
Connect the power supply
When all other cables are connected, you can connect to the power supply
of the product identification specification.
3.3. fiber port connection
3.3.1. Hot swap of SFP module
This switch provides 1000Base-X full-duplex single-mode or multi-mode
fiber interface
Warning:
This switch uses lasers to transmit signals on fiber optic cables. The laser
meets the requirements of Class 1 laser products, and normal operation is
harmless to eyes. But when the equipment is powered on, do not look directly
at the optical transmission port and the end face of the optical fiber terminator
SFP hot plug steps:
During SFP, observe the end with PCB gold finger
Insert the golden finger end into the metal shielding cage of the SFP, and
hear a clicking sound to indicate that the device has been inserted in place,
and then put the SFP plug-in handle on the normal position parallel to the
interface ,then you can use it.
SFP hot pull steps
First pull down the SFP plug-in and pull-out handle perpendicular to the
interface. At this time, the optical component should be disconnected from the
hook of the SPF shielding cage.
Pull out the SFP module in parallel
The hot plugging steps of SFP module are shown in the figure below
3.3.2. Optical fiber connection
Connect the pluggable fiber optic module steps are as follows
Remove and keep the rubber cover of the SFP port. When not use, put
on a rubber sleeve to protect the optical fiber terminator .
- 11 -