Gree GDN50BA-A3EBA2F Manual do utilizador - Página 13

Procurar online ou descarregar pdf Manual do utilizador para Desumidificador Gree GDN50BA-A3EBA2F. Gree GDN50BA-A3EBA2F 18 páginas.

2. Carry the bucket to a sink of floor drain. Keeping a hold of the handle and placing a hand under the

bucket and then leaning the container forward, empty the water content.

3. Put the drain bucket back in the dehumidifier.

► METHOD 2 – Gravity Draining Using a Hose

The drain hose is not provided, therefore the user must

purchase one. The hose thread should have an outer

diameter of 27 mm (11/16 in) and a pitch of 11.5 TPI.

1. Remove the drain bucket.

2. Thread the drain hose onto the nozzle and make sure it

is secure.

3. Put the bucket back in the unit. Make sure the drain

hose goes through the bucket's drain hole and is going

downward. Lead the hose to a floor drain, then cover

the hole with a lid. Note that drain hose should not be

pressed, otherwise the water may not be able to properly

drain out. Before disconnecting the drain hose from the

unit, be sure to place a receptacle to collect water that

may drip from the nozzle.

► METHOD 3 – Pump Draining (for models with pump only)

1. While pressing down on the plastic collar of the pump

port, pull out the water stopper.

2. Insert the drain hose into the pump port.

3. Lead the other end of the hose to a floor drain, a water

container, or out a basement window to the outdoors.

NOTES :

▪ If using the pump draining method, the unit must be set to run in Pump mode. Please refer to the

Operation Guide: Button Functions section of this instruction manual for more information.

▪ The maximum distance and elevation at which the drain hose can extend from the unit is 5 meters.

Exceeding this distance may damage the pump or cause leaks.

5. CARE AND MAINTENANCE

FIG. 11 – Correct usage of the the drain hose

Nozzle

Drain hose

FIG. 10 – Draining the condensed water

Water stopper

Pump port

FIG. 12 – Removing the water stopper

Plastic collar