Majestic FSUV30 Instruções de instalação e de utilização para os proprietários - Página 6

Procurar online ou descarregar pdf Instruções de instalação e de utilização para os proprietários para Lareira de interior Majestic FSUV30. Majestic FSUV30 16 páginas.

Imprimir página

FSUV20/30 Vent Free Gas Heater

Run Gas Line

If gas piping from the source to the heater location has

not been accomplished, install the required pipe. Con-

sult local plumbing code to assure proper pipe size.

The gas pipeline to be brought in through the rear or

the base of the heater.

NOTE: The gas line connection can be made with

properly tinned 3/8" copper tubing, 1/2" rigid pipe or an

approved ﬂex connector, then reduced to 3/8" to the

heater. Because some municipalities have some addi-

tional local codes, it is always best to consult your local

authority. Consult the current National Fuel Gas Code,

ANSI Z223.1/NFPA 54.

Always check for gas leaks with a mild

soap and water solution. Do not use an

open ﬂame for leak testing.

The gas control is equipped with a captured screw type

pressure test point, therefore it is not necessary to pro-

f i r e - p a r t s . c o m

vide a 1/8" test point up stream of the control.

When using copper or ﬂex connector use only approved

ﬁttings. Always provide a union when using black

iron pipe so that gas line can be easily disconnected

for burner or fan servicing. See gas speciﬁcation for

pressure details and ratings. NOTE: If ﬂex connector is

used, it must be kept inside of the heater. (Fig. 3)

1/2" Gas Supply

1/2" x 3/8" Shut-Off Valve

FP297

Fig. 3 Typical gas line installation.

Remote Switch

Install ON/OFF switch assembly on either the rear right

or left side of the FSHUV gas ﬁreplace.

1. Remove the screw at the back of the cabinet top

either n the left or the right side of the ﬁreplace.

2. Position switch assembly onto the back of the ﬁre-

place, then fasten two screws as shown in Figure 4.

3. Attach wiring under the clips n the rear casing (Fig.

4) and install wiring through the rear opening of the

ﬁreplace before connecting to the valve. (Fig. 5)

Installation

3/8" Nipple

3/8" Union

3/8"

Nipple

FP297

INSTA VENT FREE

R MODEL GAS SUPPLY

8/24/96

ON/OFF Switch

Assembly

Clips

Fig. 4 Position the switch assembly on back of stove.

OFF

Fig. 5 Remote switch wiring.

Slide the Heater in Place

With the fan installed, gently slide or lift the heater to

FP1586

the desired location.

Level and Secure the Heater

valve switch wire

Make sure heater is level. Shimming may be required.

Screw

(through

existing

hole)

Wiring for Mil-

livolt Gas Valve

FP1588

��

FP1586

10001784