Gree NRQD16G/A-S Manual do Proprietário - Página 12

Procurar online ou descarregar pdf Manual do Proprietário para Inversor Gree NRQD16G/A-S. Gree NRQD16G/A-S 19 páginas. Hot water converter of gmv5 home

Imprimir página

1. Introduction to Users

Notes:

① Before the welding, use wet cloth to wrap the thermal insulating bushing;

② Put the baffle between the pipeline and the wall, use two magnets to fix on the case. When welding pipelines

in the side face, the baffle should ward off the cable cross loop to prevent the fire from burning the wall and

the cable cross loop during welding.

5.1.8 Install Water Storage Tank

（1） Thermal insulating water tank should be installed within the range of 10 meters

horizontal distance and 3 meters vertical fall to the hot water converter. The water tank

can be installed outdoors with the converter, such as balcony, roof, ground, or indoors.

（2） Vertical thermal insulating water tank must be placed vertically with the feet grounded;

it is not allowed to hang in the air. The place for installation must be firm enough, and

use screw and bolt to fix the tank on the wall, for details please see below. Take the

bearing capacity of installing position into consideration when installing the water tank.

（3） There should be tap water pipe, hot water interface and floor drain around the thermal

insulating water tank for easily adding water, supplying water and draining water.

（4） Connection of inlet and outlet water pipelines: connect the safety check valve (note that

the arrow "→" points at the thermal insulating water tank) to water inlet of water tank

with PPR pipe, and seal with raw material belt; connect another end of safety check

valve to water adding end of tap water. Connect the hot water pipe to water outlet of

thermal insulating water tank with PPR pipe.

Hot water converter of GMV5 Home Installation and Operation Manual

Fig. 5.6