Adexa YSD-8A Manual do utilizador - Página 4

Procurar online ou descarregar pdf Manual do utilizador para Forno Adexa YSD-8A. Adexa YSD-8A 7 páginas. Electric convection oven

A. General Introduction

The Electric Convection Oven uses hot air circulation mode, so the temperature up quickly and

heat evenly. The oven also has timer and thermostat, so the user can accord needs adjust the

time and the temperature. The oven has steam function, and the operator can add the steam to

the food. The glass of the door has two layers, so it is beautiful and it can insulate heat. There

is a micro-active switch beside the door. When open the door, the fan will stop turning. This

can avoid the hot air hurt anybody. The oven is adapted to place in front of the supermarket

and fast-food restaurant.

1.2 Technology Parameter

Dimension: 834×796×572mm

Voltage: 230V/50Hz

Power: 6.4KW

Water Pressure: 50~200kPa

1.3 Safety Attention

1. The oven must be placed on an even surface, and the both sides far away from the inflammable

materials at least 10cm. The user should install a suitable power switch and fuse breaker near

the machine in order to normal maintenance. Don't put anything in front of the switch, easy to

operation.

2. All the users must follow the safety electric standard. Before using, make sure the power

voltage corresponds to that stated on the data plate, and well ground connection.

3. Only use the oven under safety conditions. If there is any trouble, must maintain it at once.

4. The oven must be test before using.

5. The maintenance and the installation must be operated by professional people. Before carrying

out any type of maintenance it is necessary to disconnect the electric power supply and wait for

the appliance cool down.

6. During the operating, don't touch the oven in case of scald.

B. Installation

2.1 Electrical Connection

1. The connection to the electric power supply must be done according to the standard.

2. Before installation, make sure the power voltage corresponds to that stated on the data plate.

2.2 Water Connection

1. Use a 1/2''dia.water tube connects to the magnetic-valve, and fixed firmly in case of water

leakage.

2. Let a certain quantity of water flow to clean the duct. The water must have a hardness between

0.5°-5°F(this is in order to reduce the formation of limestone deposits )and the water

pressure between 50~200kPa.