Bristan Pear Instruções de instalação e manual do utilizador - Página 7

Procurar online ou descarregar pdf Instruções de instalação e manual do utilizador para Produto de canalização Bristan Pear. Bristan Pear 12 páginas. Monobloc sink mixer with pull out spray

Imprimir página

Installation Cont.

7. Connect small end of pull out hose (25) using sealing washer provided to end of pull-out hose

connector (24) already fitted in base of mixer and tighten fully.

8. Split the two halves of the black hose weight (19) by removing wire spring clip and place both

halves around a vertical section of black hose (25) under the fitted mixer so that it is pulling

the pull-out handset back into the mixer body spout and replace wire spring clip.

9. Connect both inlet flexi connecting pipes (18) to the hot and cold water supplies/household

pipe work. (The cold inlet pipe under the mixer should be on the right and hot on the left

when viewed from the front.)

Flexible Connecting Tails:

Care must be taken when connecting the

flexible connection pipes to the household

pipework to ensure they do not bend sharply

and kink or twist.

Important: Failure to follow these guidelines may result in poor performance and damage

to the flexible connecting pipes.

10. Carefully turn on both water supplies and gently turn on mixer by lifting the lever to the

fully on position and let run for a few minutes checking all joints and connections for leaks.

Operation

Moving the lever upwards/downwards from the mixer body will turn on/off and

increase/decrease the flow of water.

Moving the lever either to the left or right when in the up position (when the mixer is viewed

from the front) will increase/decrease the water temperature.

The pull out handset incorporates a push button, enabling the water flow to be altered from an

inner water stream to a wider outer spray pattern.

See below for recommended ways to fit the

flexible connecting pipes.