Majestic Appliances MJ-9200D Manual do Proprietário - Página 6

Procurar online ou descarregar pdf Manual do Proprietário para Secador Majestic Appliances MJ-9200D. Majestic Appliances MJ-9200D 16 páginas. Vented separate/stacking dryer
Também para Majestic Appliances MJ-9200D: Manual do Proprietário (15 páginas)

Imprimir página

Electricity

instal1

y@ur

Make sure the voltage and frequency available correspond with the values stated on the data plate located at the

back of the machine and that the efectdc system is dimensioned

to withstand the maximum current shown on the

data plate If the socket the machine is connected to does not correspond with the plug, replace the outlet with a

suitable one arid avoid using adapters or shunts since they could cause over heating and burn out

Grounding

This appliance must be grounded

In the event of malfunction or- breakdown, grounding will reduce the risk of

electric shock by providing a path of least resistance for electric current, This appliance is equipped with a cord

having and equipment-grounding

conductor and a grounding plug. The plug must be plugged into an appropriate

outlet that is properly installed and grounded in accoi"dance with alt local codes and ordinances

WARNING- Improper connection of the equipmenbgrounding

conductor can result in a risk of electric

shock Check with a qualified or service representative

or personnel if you are in doubt as to whether the

appliance is properly grounded

Do not modify the piug provided with the appliance: if it will not fit the outlet, have a proper outlet installed

by a qualified electrician

Electrical Specifications:

Voltage/Amperage

- 115V DC, 12 Amp, 60 Hz

3 Prong plug attached to the appliance in the factory

Circuit/Protection

- 3 wires single phase, 120V, 60 Hz, AC separate 15 or 20 amp circuit or greater..

Recessed,

@l@set and Aic@ve

Inst:allatieas

This appliance

may be installed

in a recessed

area, closet

or alcove.

All measurements

are in

inches.

• if the appliance is to be installed in a closet with zero clearance on the sides of the appliance, a total of 12 square

inches of free air space movement to the back of the unit must be allowed into the closet

• If a door is to be installed that potentially encloses the unit while running, the door must allow for a minimum of

20 square inches of free air movement

There must also be a 1" space frorn the front of the unit to the closed door

and 1" from the back of the unit to the wall Additional spacing should be considered for easy installation, servicing,

removal and compliance with applicable local, state and federal codes.

•The floor must be able to support at least 280 lbs and a surface that is solid and level

• Installations in RV's or Marine pleasure craft suggest that the machine might best be installed midships in the

boat, or over the axies of the RV where movement is at a minimum

Adequate blocking should prevent extreme movement when installed in an RV or Marine pleasure craft

Fronl View (Recessed)

if the

appliance

is to

be instagJed

in a closet,

the

installation

must

completed

by a quaSi-

fled person

or service

representative.

Add_t_o.ag

cgearances

for floor,

waBg or door

_oad_ngs

may

required.

PaNe 5

@2003 Manufacturers Supply Inc

Side View (Recessed)