Bristan W BTH12 G Instruções de montagem - Página 2
Procurar online ou descarregar pdf Instruções de montagem para Produto de canalização Bristan W BTH12 G. Bristan W BTH12 G 2 páginas. Exposed bath waste
Imprimir páginaINSTALLATION
N.B. please quote the name and product code of your fitting should
need to phone the help line.
regarding any inquiries.
1. Identify all components and check for completeness.
2. Assemble waste as shown by sliding nuts (2) onto tube with washer
(3) and rubber seal (4) inside each nut. Slide tube into waste body (14)
and overflow elbow (5) and tighten nuts. The waste can be adjusted to
fit bath by raising or lowering overflow elbow on tube.
3. The small foam washer (6) and the waste seal (13) go between the
overflow elbow and the waste body, respectively, and the bath.
Use a pure Silicon sealant where necessary.
4. Screw the overflow face (7) to the overflow elbow. Screw the waste
flange (11) to the waste body, making sure the large foam washer (12)
is between flange and bath.
Use a pure Silicon sealant where necessary.
5. If not fitted, open the triangular hook on the plug chain and close into
plug, then attach the other end of the chain to the overflow face.
6. Check all joints and connections for leaks.
7. See over the page for aftercare instructions.
COMPONENTS
1.
Waste tube
2.
Nut
3.
Washer
4.
Rubber seal
5.
Overflow elbow
6.
Small
foam
washer
This will ensure a speedier service
8.
Screw
9.
Chain assembly
10. Plug
11. Waste flange
12. Large
foam
washer
13. Waste seal
14. Waste body