Gamko X/ACCELS1 Manual - Página 12
Procurar online ou descarregar pdf Manual para Equipamento comercial para alimentos Gamko X/ACCELS1. Gamko X/ACCELS1 13 páginas.
Imprimir páginaConnecting heating wire (to
48
24V LED
24V CELS+
heating wire
230VAC
Connect heatingwire parallel to 24V powersupply
- Flexbar without CELS: use new powersupply
- Flexbar with CELS: use CELS powersupply
- Do NOT use RGB LED powersupply!
Ergonomic light - installation
51
(white light behind solid doors with doorswitch)
1
2
1 Connect reed switches in series
2 Make sure the gap between the reed switches and the
magnet is not too big
if necessary place extra washers between hinge and door
Ergonomic light - production
49
(white light behind solid doors with doorswitch)
prevent condensation)
006130053
24VDC RGB LED
24VDC CELS
DETAIL F
24VDC heating wire
1 Place magnet in hole opposite of hinge
top of magnet must be flush with door
52
Temperature
sensor
Reed switches
3 Connect reed switches in the electrobox
on pin14 (digital output) and together with
the temperature sensor on pin12
4 Remove jumper on back of display
F
Ergonomic light - installation
(white light behind solid doors with doorswitch)
4
Jumper
3
name
destination
1
1
Ergonomic light - production
50
(white light behind solid doors with doorswitch)
align
Reed switch
008110167
*
*
2 oppervlak ontvetten
3 plak read switch mbv VHB tape in oversteek
4 reed switch uitlijnen met scharniergat (zie illustratie)
(zorg ervoor dat de magneet uitlijnt met de
53
Placing X/EP02
Place X/EP02 to segment, align top and front and fix using
4x40mm (012100509) screws in the 4 pre-punched holes
Make sure the screw heads end up flush with side
Algemene installatie instructie
drawing nr.
Flexbar
02/09 DMX + CELS
02/09 DMX + CELS
5611
5611
draftsman
align with hinge hole
)
*
012100509
Gamko Holding BV
Mon Plaisir 75
196169
GB
4879 AL Etten-Leur
Tel.(0)76-5087500
The Netherlands
Blad 12 van 13
date
edda
21-1-2009
Service