Gamma 5002 Manual do Proprietário - Página 9

Procurar online ou descarregar pdf Manual do Proprietário para Máquinas de encordoar Gamma 5002. Gamma 5002 18 páginas.

aligns with the line on the knob support. To decrease tension by 1 or 2 lbs, turn the knob

clockwise until the "2" or "1" mark on the knob aligns with the line on the knob support.

friction between the clamps and the string to allow for reduced clamping pressure while

securing and holding the string under tension.

STRINGING THE FRAME

Travel Stop

Setting Tension

The GAMMA 5002 utilizes a rotary adjusting

knob along with a linear tension scale to

indicate the tension setting. The scale is

divided into 3 lb increments and each 1/3 turn

of the tension knob changes tension by 1 lb.

To set the desired tension, rotate the tension

knob and align the mark on the spring guide

with the desired tension setting on the scale.

When the "0" mark on the knob aligns with the

line on the knob support the tension will be

that indicated on the scale. To increase ten-

sion by 1 or 2 lbs turn the knob counterclock-

wise until the "1" or "2" mark on the knob

Tensioner Travel Stop

To prevent contact between the tension head

and the racquet and/or turntable, a stop

screw is located about midpoint along the

tensioner bar below the gear track. In the

event the tension head must be moved closer

to the racquet, turn the stop screw counter-

clockwise with the 5 mm hex wrench until the

end of the stop screw no longer protrudes

beyond the surface of the tensioner bar. To

re-engage the stop, simply turn the stop

screw clockwise until the screw is seated

against the tensioner bar.

Fixed Clamp Operation - Step 1

The fixed clamps for the GAMMA 5002 are of

a dual action design. The string clamp and

the clamp base operate independently of

one another.

To clamp a string, lift the clamp head and

place the string between the jaws. Depress

the clamp head lever to secure the string.

The clamping pressure applied to the string

should be adjusted to provide sufficient pres-

sure to secure the string when subjected to

the desired pulling tension. The diamond

coated gripper plates provide for increased