Gamma 5003 Manual do Proprietário - Página 16

Procurar online ou descarregar pdf Manual do Proprietário para Máquinas de encordoar Gamma 5003. Gamma 5003 19 páginas. 6 point mounting
Também para Gamma 5003: Manual do Proprietário (20 páginas), Manual do Proprietário (20 páginas), Manual do Proprietário (20 páginas)

Imprimir página

1. Tension Calibration

TROUBLESHOOTING TIPS

PROBLEM

String slips in clamps

String slips in gripper

String clamp slips on base

String tension too tight or too loose

For additional assistance, contact Gamma Sports Customer Service at 1-800-333-0337

With time and use, the clamping surfaces of your machine may become oily or dirty and result in string or clamp

slippage while stringing. Periodic cleaning of the following parts is recommended.

String Clamps

Clean the inside gripping surfaces of the string clamp jaws by inserting a cloth or pipe cleaner soaked with isopropyl

alcohol between the jaws and rub back and forth. If the build-up is excessive, dismantle the string clamp jaws to

expose the gripping surfaces by removing the adjustment screw. Using a small nylon brush (such as a toothbrush),

a flat sharpening stone, or an ermery board, scrub the inside surfaces until all debris is removed. Clean the jaws

with isopropyl alcohol and re-assemble.

String Clamp Base

Clean the base of the clamps and the top of the turntable with isopropyl alcohol.

String Gripper

Clean inner gripping surfaces with isopropyl acohol soaked cloth or pipe cleaner. In cases where there is a lot of

build-up, use a flat emery board and scrub the surfaces first.

- Adjust gap between jaws

- Clean clamp jaws

- Clean gripper jaws

- Adjust Gripper Jaw Stop Screw

- Clean base of clamp and top of turntable

- Adjust Clamp Base Locking Nut

- Check tension using a tension calibrator and

adjust machine calibration if necessary

CARE and CLEANING

SOLUTION