jakar SCISSORS Manual do operador - Página 7

Procurar online ou descarregar pdf Manual do operador para Máquinas de jogos de arcada jakar SCISSORS. jakar SCISSORS 15 páginas.

ADVICE: Before CALIBRATION XYZ do TEST XYZ first. Only if you notice any errors during the test, do the

calibration:

1. Using SET button in ADVANCE SCISSROS SETUP go to option TEST XYZ and press DOWN & UP

simultaneously.

2. Using

button on the front panel, place the scissors mechanism as close to the rope as possible,

remembering not to reach the rope. Once it is done, accept the setting by pressing

3. Now check calibration: The mechanism goes to one rope two times. Firstly, to the left side. The

successful calibration is when the rope is placed min.1 mm from the break.

The rope cannot be placed in the break or on its edge.

4. Then the mechanism goes to the right side. The successful calibration is when the rope is placed min

1 mm from the razor (on the white part above the razor, not on the edge).

5. Repeat the process with each rope. If during the test any rope was placed in the break or on its edge,

just remember the number of that rope, and continue the test till the last rope is tested.

6. If all the ropes are tested, TEST XYZ is finished.

Attention: If any rope was placed wrongly (in the break or on its edge) you have to do CALIBRATION

XYZ but only with those wrongly calibrated ropes. To do so, follow the steps below.

To do CALIBRATION XYZ follow the steps:

1. Turn on the machine and make sure that there is no credit.

2. On the remote control press DOWN & UP buttons simultaneously to enter ADVANCE SCISSROS

SETUP. Now, using SET button go to CALIBRATION XYZ, and press again DOWN & UP buttos at

the same time to start calibration.

3. Using

button on the front panel, place the scissors mechanism as close to the rope as possible,

remembering not to reach the rope. Once it is done, accept the setting by pressing

4. Calibration begins: Using

side from the break but no farther than 1 mm. If it is done, press

(It is very important not to move the mechanism too many times while setting it. It is much better to move it

only few times, even if the rope is placed more than 1 mm from the break).

SCISSORS – operator's manual/instrukcja użytkownika

VI. CALIBRATION XYZ

TEST XYZ

button on the front panel, place the rope on the mechanism on the left

button.