Gamma X-6 Manual do Proprietário - Página 8

Procurar online ou descarregar pdf Manual do Proprietário para Máquinas de encordoar Gamma X-6. Gamma X-6 16 páginas.
Também para Gamma X-6: Manual do Proprietário (15 páginas)

Imprimir página

STRINGING THE FRAME

Setting Tension

To set the stringing tension, loosen the

locking knob on the side of the drop weight.

Slide the weight in the appropriate direction

until the face closest to the string gripper is

indexed with the desired tension mark on

the tension bar.

The drop weight is of a two piece design.

When assembled, it will accommodate ten-

sions from 20 to 90 lbs For tensions from 8

to 20 lbs, remove the 5mm bolt on the face of

the drop weight, and use the smaller portion

of the weight as described above.

Note: Tensions above 77lbs require the

removal of the drop weight bar end cap.

Clamping the First Main String

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and pull

the excess by hand. Using a ﬂ oating clamp,

secure the center and the adjacent string to

each other on the inside of the frame.