Bristol Clifton 8 Manual do utilizador - Página 6

Procurar online ou descarregar pdf Manual do utilizador para Fogão Bristol Clifton 8. Bristol Clifton 8 16 páginas. Multifuel stoves

Imprimir página

Clearances

Materials above the stove are far more likely to overheat than materials alongside or below. A guideline limiting

temperature for solid timber (not surface ﬁnishes) is approximately 80-85 degrees C with a normal ambient room

temperature. Temperatures of combustible materials can be substantially lowered with a simple heat shield constructed

of a non-combustible material (e.g. metal or ﬁreproof board etc.) and a small air gap (25mm ) between the shield and

combustible material. See Hetas technical notes TN_0023

Model

Clifton 4

Clifton 5

Clifton 8

The stove can be recessed in a suitable sized non-combustible ﬁreplace or stood close to non combustible materials,

but a permanent free air gap of 150mm is recommended to be left around the sides and 300mm above & at least 50mm

at the back of the stove to obtain optimum heat output and for access to the stove for removal and maintenance.

These sizes may be reduced to 50mm but may aﬀect heat output to the room.

For corner installations the same guidelines apply but consideration should be taken to allow for the door to be fully

opened.

Curtains and soft furnishings should be a minimum of 1m away from the appliance.

In accordance with Building regulations all non-combustible walls closer than 400mm to the stove should be at least

75mm thick. For practical reasons the back wall of the ﬁreplace recess and the hearth should be made of non-

combustible material.

CO Alarm:

Building Regulations require that whenever a new or replacement ﬁxed solid fuel or wood/biomass appliance is installed

in a dwelling a carbon monoxide alarm must be ﬁtted in the same room as the appliance. Further guidance is available

in BS EN50292:2002 and from the alarm manufacturer's instructions. Provision of an alarm must not be considered a

substitute for either installing the appliance correctly or ensuring regular servicing and maintenance of the appliance

and chimney system.

4. Operating Instructions

Door Handle

The door handle is located to the right hand side of the door. Turn the handle to open.

Air Controls

Keep all air controls inlets & outlets clean and free from debris or ash at all times . Do not leave air controls fully open

unless monitoring the ﬁre. Do not use with the door open. Over ﬁring will cause damage and as a result will not be

Primary Air

Primary air is controlled through the lever at the bottom of the door this is the left hand lever. Push in to restrict air & pull

out to increase air supply. This provides a primary air draught which passes under the grate through the fuel bed. The

primary air intakes can be adjusted to control the ﬁre in combustion chamber for smokeless fuels. It is not necessary to

use primary air for burning wood, unless boosting a low ﬁre bed or your ﬂue draught is very low. Operation of the air

controls fully open can cause excess smoke and must not be used fully open for long periods of time.

Secondary Air

Secondary air is controlled through the lever at the bottom of the door this is the right hand lever. Push in to restrict air

& pull out to increase air supply. The appliance is ﬁtted with an "air wash system" which assists in keeping the ﬁre as

visible as possible this does not eliminate periodic cleaning of the ceramic glass. Operation of the air controls fully open

can cause excess smoke and must not be used fully open for long periods of time.

The Clean Air act restrictor will deliberately prevent full closure of this lever.

Distances to Combustibles

Sides

500mm

covered by any warranty

Rear

600mm

750mm

Front

1000mm

1200mm