decina Prelude 1000 R4SHC1101R4 Manual de instalação - Página 7

Procurar online ou descarregar pdf Manual de instalação para Luminárias de casa de banho decina Prelude 1000 R4SHC1101R4. decina Prelude 1000 R4SHC1101R4 11 páginas. Shower bases & acrylic shower wall

Imprimir página
6mm min
Once sheeting is completed, use a flexible waterproof sealant (not supplied) to seal
the gap between the shower base tile bead and the wet area sheet.
FOR STEEL STUD WALL FRAMES WITH ACRYLIC SHOWER WALL
APPLICATIONS - SEE BELOW
NOTE: As a steel wall stud should not be cut, it
•
is necessary to build out the wall level to clear
the shower base tile bead thickness.
A suitable wet area sheet product of no less
•
than 12mm thickness is required to achieve
the desired level. Use of either a 13mm Wet
Area Plasterboard or 12mm Wet Area Fibre
Cement sheet is advised.
Install the chosen 12 or 13mm wet area sheet
•
product bottom edge at least 6mm above
the tile bead (as per relevant manufacturer's
instructions).
Once sheeting is completed, use a flexible waterproof sealant (not supplied) to
•
seal the gap between the shower base tile bead and the wet area sheet.
S H OWE R IN STA LLATI O N G U I D E
12
6mm min
© Copyright Decina Bathroomware Pty Ltd 2016
11
ACRYLIC SHOWER WALL LINER
INSTALLATION
DRILLING TAP HOLES IN ACRYLIC WALL
Have a qualified tradesperson install the shower
•
fittings. Mark the position of the holes for the fittings
on acrylic shower wall.
Large holes must be drilled with a fine tooth hole saw.
•
Holes should be drilled from the outside show face only
•
Ensure all final hole sizes have at least a 2mm
•
clearance around tap fittings for expansion.
ATTACHING THE ACRYLIC SHOWER WALL
Positioning shower wall
Trial position the shower wall against the shower recess, ensuring it fits squarely
•
into the recess corner and shower base.
Tape the corners with masking tape to hold the liner in position.
•
Use a soft pencil to mark around the edges of the shower wall before removing.
•
© Copyright Decina Bathroomware Pty Ltd 2016
2mm min
clearance
13
SH OW ER I NS TA LLATI O N G UI DE