decina SOFIA SHOWER PANEL Instruções de instalação - Página 2

Procurar online ou descarregar pdf Instruções de instalação para Luminárias de casa de banho decina SOFIA SHOWER PANEL. decina SOFIA SHOWER PANEL 4 páginas.

Imprimir página

INSTALLATION

IMPORTANT INFORMATION

•

THIS SHOWER PANEL IS DESIGNED FOR FLAT WALL MOUNTING ONLY!

•

We recommend that the shower panel's mounting brackets are secured into a wall stud. If unable to, prior to installation make

sure that wall can support a load of 12kg.

•

Do not drop the back flow filters on both ends of the control valve when you remove the cap.

•

Rinse all debris from the water supply system, otherwise the cartridge inside the thermostat valve will be damaged.

•

The HOT and COLD water hoses are connected with ½" BSP fittings. The male connector on the wall must be running parallel

to the wall, a 90° elbow may be required to achieve this.

•

Before beginning installation, please inspect your shower panel to ensure there is no damage. If you find any abnormality,

please immediately return the product with all its original packaging to your licensed dealer.

•

Please leave your Shower Panel in its original packaging until you are ready for the installation.

* PRIOR TO INSTALLATION MAKE SURE YOUR HOT & COLD WATER VALVES ARE CLOSED

STEP 1: REMOVE & INSPECT THE SHOWER PANEL

* THE IDEAL DISTANCE BETWEEN YOU & THE RAINFALL SHOWER IS 20

STEP 2: INSTALLATION OF YOUR SHOWER PANEL TO THE WALL

1. To attach the mounting

brackets to the wall, measure

the distance between the two

supports on the back of the

shower panel, this should be

roughly 915mm.

For the ideal mounting

position refer to the

technical drawings on the

opposite page>>

2. Drill holes in the wall for

the two brackets according to

the distance obtained in the

step before.

3. Insert the plastic pegs and

screw them into the wall,

while holding the bracket in

place. Use a level to ensure

the brackets are straight.

Avoid over tightening the

screws.

4. Connect the HOT and COLD

water pipes and thoroughly

test for any leaks.

5. Mount the shower

panel onto the wall brackets,

ensuring they are resting in

the correct positions on the

back of the panel. Once the

panel is secure and in place

run a line of silicone down

each side of the panel.

6. Assemble the hand shower

and attach it to the shower

panel.