decina ARIA Instruções de instalação

Procurar online ou descarregar pdf Instruções de instalação para Casas de banho decina ARIA. decina ARIA 2 páginas. Back to wall universal toilet suite artswfs

Imprimir página

INSTALLATION INSTRUCTIONS

ARIA

BACK TO WALL UNIVERSAL TOILET SUITE

ARTSWFS

PRE INSTALLATION CHECKS - THIS PRODUCT MUST BE INSTALLED BY A LICENSED PLUMBER

1. Check that the toilet is compatible with your current set out requirements. This Overture has a set out distance of 90-180mm

for S Trap and 180mm for P Trap.

2. This toilet comes with an S Trap Vario Bend. P Trap connection IS NOT PROVIDED.

3. Before installing your new toilet please make sure you have received all items and that they are undamaged. Any damage

claims after installation WILL NOT BE ACCEPTED.

4. Check that the floor and wall are level and perpendicular.

5. This product is configured for bottom/side entry. For rear entry you need to purchase a rear entry kit (sold separately).

INSTALLATION

1. Feed a flexible connecting hose (sold separately) through

the side entry and through the top of the Pan.

2. Floor Fixing Kit - measure and install the floor fixing kit

(see instructions in kit). DO NOT INSTALL the external locking

SS screw at this stage.

3. Ensure the Foam/Donut Seal is placed over the Outlet Flush

Pipe on the base of the Cistern.

4. Connect the Water Supply Hose to the base of the Cistern

Inlet Valve.

5. Connect the Cistern and Pan together and lock into place

using the fixing bolts provided (the outlet flush valve can be

removed to assist with the bolt assembly by turning it anti

clockwise and then lifting it out).

6. Insert the Vario Bend onto the Pan Outlet Spigot.

If trimming is required work out the measurement and

mark the cutting line.

7. Check the measurements and then cut the Vario Bend to

the correct length.

8. Place Rubber Seal and Cover over the front of the Vario

Bend and install, ensure that the sewer connection is

connected correctly and a good seal has been achieved.

9. Install the Flush Buttons onto the Cistern lid.

NOTE - Button toggles can be adjusted

NOTE - This toilet is not suitable to be used with some

offset collars and slab adapters.

Before fixing the toilet to the floor, connect the water

supply and ensure that the toilet is working correctly by

doing several flush tests, checking for leaks. Once you are

confident that there are no leaks and the toilet is working

correctly install the Pan into the Floor Fixing Kit provided

and apply a bead of Wet Area Silicone around the base of

the Pan (you will need to allow for the recommended drying

time). Install the seat after the Silicone has dried.

Refer to Seat installation instructions.