KitchenAid 30" Instruções de instalação - Página 5

Procurar online ou descarregar pdf Instruções de instalação para Placa de fogão KitchenAid 30". KitchenAid 30" 8 páginas.

Imprimir página

B. Strain relief required

Clamping

Insert from

screws

"--J

under frame

4. Replace terminal block cover.

Disconnect

clamping

ring from strain relief. Push

relief (from bottom) through hole beneath terminal

block. Tighten clamping ring (from above) onto

strain relief threads.

Run cord through

strain relief

Run (cord or cable through strain relief.

Leave enough slack to attach ring-type terminals to

terminal block. Tighten clamping screws.

C. If ii-ame grounding

is allowed

Lir!el

Line 2

Y--l*

relic,

Stram

Use this wiring method ONLY if local codes permit

connecting frame grounding conductor to neutral

wire of power cord.

THIS APPLIANCE IS MANUFACTURED WITH NEU-

TRAL TERMINAL CONNECTED TO THE FRAME.

Connect neutral wire to the center silver-colored

terminal.

2. Connect remaining

2 wires to the terminals on

either side of the silver-colored

terminals.

3. Use ring type terminals

only. Connect with the

brass nuts that are taped to the frame. Do not

loosen factory installed nuts already on the

terminal.

D. 4-w&e electrical

connections

If local codes do not permit grounding

through the

neutral,

the 3-conductor

cord or cable assembly

must be replaced by a 4-conductor

cord. The

replacement

cord must be rated at 240 volts, 50

amperes and investigated

for use with ranges.

Silver-colored

terminal

Line 1 If-

/s%

f-----W

Line 2

Use this wiring method for mobile homes and

whenever a 4-wire installation is required.

Remove the grounding

strap screw from the

range frame. Keep this grounding

screw. Bend up

the grounding

strap so that it does not contact the

range frame.

2. Connect the green grounding

wire to the frame of

the appliance

with the grounding

screw, using the

hole in the frame where the grounding

strap was

removed.

3. Connect the white neutral wire of the power

cord to the silver-colored

terminal of the terminal

block. Connect the remaining wires to the outer

terminals.

4. Replace the terminal block cover.

Neutral

(white or center)