KitchenAid GCI3061 Manual de instruções de instalação - Página 4
Procurar online ou descarregar pdf Manual de instruções de instalação para Placa de fogão KitchenAid GCI3061. KitchenAid GCI3061 12 páginas. 30" (76.2 cm) electric induction cooktop
Também para KitchenAid GCI3061: Manual de instruções de instalação (12 páginas)
Imprimir página
Ifthehouse h as aluminum w iring, follow theprocedure
below:
1. Connect asection o fsolid copper wire tothepigtail
leads.
2. Connect thealuminum w iring totheadded section o f
copper wire using special connectors and/or tools
designed andULlisted forjoining c opper toaluminum.
Follow theelectrical connector manufacturer's
recommended
procedure. Aluminum/copper
connection must c onform with
local c odes a ndindustry a ccepted wiring practices.
INSTALLATION INSTRUCTIONS
1=
2.
Decide on the final location for the cooktop.
NOTE: Countertop
must be 13Ae '' (3.0 cm) to 2" (5.1 cm) thick.
If necessary, make cutout in countertop before installing
cooktop. See "Location Requirements" section for more
information.
4. Position brackets in the center of the vertical centerline and
align the upper edge of the brackets so that they are flush
with the countertop.
3. Clean cutout of any remaining dust and debris.
NOTE: Kit Part Number W10310006 is required for installing the
cooktop into a solid surface or marble countertop.
See the
"Assistance
or Service" section of the Use and Care Guide for
information
on ordering.
To Install Brackets
into Marble Countertop:
1. Clean the brackets and cooktop cutout of any dust and
debris.
5. Push the brackets firmly onto each side of the cooktop cutout
and wait 1 hour for adhesive to dry.
2. Measure the center line of the vertical sides of the cooktop
cutout.
Center line
3. Apply the adhesive provided in the kit to the back side of the
brackets.
/JJ
To Install Brackets
into Wood Countertop:
1. Measure the center line of the vertical sides of the cooktop
cutout.
2.
3.
Center line
Position brackets in the center of the vertical centerline and
align the upper edge of the brackets so that they are flush
with the countertop.
Attach the brackets in the cutout with the screws provided.
A
B
A. Bracket
B. Screw