Centurion D5-EVO REPAIR Manual de configuração - Página 2
Procurar online ou descarregar pdf Manual de configuração para Abertura de portões Centurion D5-EVO REPAIR. Centurion D5-EVO REPAIR 13 páginas. Sliding gate operator
Também para Centurion D5-EVO REPAIR: Manual de instruções de instalação (14 páginas), Manual de programação (4 páginas)
Imprimir página
Prior to commissioning the system, please ensure that you
have connected the wiring of all components in the system to
the controller terminals correctly. Kindly refer to the diagrams
provided on the back of this document for details.
1. If powering up the system
ex-factory, it will request for
the operating Profile
(operating standard) to be
set.
ZA: Standard profile for
South Africa
CE: Standard profile for
the European Union
UL325: Standard profile
for the USA compliant
with requirements but not
certified
2. Select the Profile that will
suit the specific region from the list. With this set, the system will
automatically proceed to the Limit Setup Menu. Follow the
onscreen instructions to complete the setup procedure.
3. If powering up at any stage after this, push and hold the oblong
enter button (
pressing the enter button (
complete the setup procedure.
Section 3 below provides the full menu of features that can be set up
on the system.
An explanation of each feature is provided in Section 21, Controller
Features of the full installation manual available on
www.centsys.co.za.
When setting up the D5-Evo and D10 system via the LCD display, all
the steps that have to be followed are clearly provided via the display.
It is only necessary to note the following:
To get into Setup Mode, press the (
follow the instructions provided
The buttons provided on the controller for navigating the system are
not marked because at each step during the setup, the function
given to each button is provided on the display
When not in Setup Mode, i.e. Normal Mode, the (
used as a test button for operating the system
The triangular up or down (
the diagnostic screens
For each feature a Factory Default Setting has been programmed
into the controller. Referred to as an Operating Standard or
Profile, these defaults have been determined to suit the
requirements of the specific region where the installation is being
carried out. It is only necessary to change a feature where the
default does not suit the installation. When selecting any feature in
the menu, details of the current setting stored in the controller are
displayed
) for two seconds. Select the Limits Menu by
). Follow the onscreen instructions to
) button for two seconds and
) buttons are used to scroll through
) button is