Major tech MTD15 Manual de instruções - Página 4

Procurar online ou descarregar pdf Manual de instruções para Instrumentos de medição Major tech MTD15. Major tech MTD15 12 páginas. 400a ac clamp meter

Imprimir página

1. SAFETY

1.1. lnternational Safety Symbols

This symbol, adjacent to another symbol or terminal, indicates

the user must refer to the manual for further information.

This symbol, adjacent to a terminal, indicates that, under

normal use, hazardous voltages may be present.

Double insulation.

1.2. Safety Notes

• Do not exceed the maximum allowable input range of any function.

• Do not apply voltage to meter when resistance function is selected.

• Set the function switch OFF when the meter is not in use.

1.3. WARNINGS

• Set function switch to the appropriate position before measuring.

• When measuring volts do not switch to current/resistance modes.

• Do not measure current on a circuit whose voltage exceeds 240V.

• When changing ranges always disconnect the test leads from the circuit

under test.

• Do not exceed the maximum rated input limits.

1.4. CAUTIONS

Improper use of this meter can cause damage, shock, injury or death. Read

and understand this user manual before operating the meter.

Always remove the test leads before replacing the battery.

Inspect the condition of the test leads and the meter itself for any damage

before operating the meter. Repair or replace any damage before use.

Use great care when making measurements if the voltages are greater than

25VAC rms or 35VDC. These voltages are considered a shock hazard.

Remove the battery if the meter is to be stored for long periods.

Always discharge capacitors and remove power from the device under test

before performing Diode, Resistance or Continuity tests.

• Voltage checks on electrical outlets can be difficult and misleading

because of the uncertainty of connection to the recessed electrical

contacts. Other means should be used to ensure that the terminals are

not "live".

• If the equipment is used in a manner not specified by the manufacturer,

the protection provided by the equipment may be impaired.