IKEA GENAST Manual do utilizador - Página 9
Procurar online ou descarregar pdf Manual do utilizador para Forno IKEA GENAST. IKEA GENAST 28 páginas. Built-in oven
Imprimir página
ENGLISH
Daily use
Start protection / key lock
This automatic safety function is activated
one minute after the oven has returned to
"stand by mode". (The oven is in "stand by"
when the 24-hour clock is displayed or if the
clock has not been set, when the display is
blank).
The door must be opened and closed
e.g. putting food into it, before the safety
lock is released. Else the display will show
"DOOR".
Cooling down
When a function is finished, the oven
may carry out a cooling procedure. This
is normal. After this procedure the oven
switches off automatically.
If the temperature is higher than 100°C,
"HOT" and the current cavity temperature
are displayed when the oven is in stand-
by mode. Be careful not to touch the cavity
inside when removing food. Use Oven
mittens.
"HOT" warning will remain active until the
cavity temperature is below 50°C.
The cooling procedure can be interrupted
without any harm to the oven by opening
the door.
Settings
When the appliance is first plugged in it will
ask you to set the clock.
After a power failure the clock will flash and
needs to be reset.
Your oven has a number of functions which
can be adjusted to your personal taste.
1
2
1. Press the Stop button until Setting is
shown (aprox. 3 sec).
2. Use the Adjust knob to choose one of
the following settings to adjust
Clock
Sound
ECO
Brightness
3. Press the stop button to exit the settings
function and save all your changes when
you are done.
Clock
1. Press the OK button (the left-hand digits
(hour's) flicker).
2. Turn the Adjust knob to set the hours.
3. Press the OK button (the two right hand
digits (minutes) flicker).
4. Turn the Adjust knob to set the minutes.
5. Press the OK button again.
The clock is set and in operation.
If you wish to remove the clock from the
display once it has been set simply enter the
clock setting mode again and press the Stop
button while the digits blink.
Sound
1. Press the OK button.
2. Turn the Adjust knob to turn the sound
ON or OFF.
3
3. Press the OK button again to confirm the
change.
9
2 4
1 3 5
1 3
2