DECKORATORS ALX CLASSIC Instruções de instalação

Procurar online ou descarregar pdf Instruções de instalação para Equipamento para relva e jardim DECKORATORS ALX CLASSIC. DECKORATORS ALX CLASSIC 4 páginas. Complete kit
Também para DECKORATORS ALX CLASSIC: Instruções de instalação (3 páginas)

Imprimir página

• Drill/power screwdriver

• Miter or circular saw

with carbide tip blade

• Marked speed square

• Carpenter's level

• Carpenter's pencil

2 - 6' or 8' aluminum rails with baluster connectors installed

4 - line brackets

16 - #8 x 3/4" screws

4 - Christmas tree screws

15 - (satin black, matte black, or textured white) classic or estate balusters for 6' section

(20 balusters for 8' rail section)

In-Line Railing Installation Instructions

Prior to construction, check with your local regulatory agency for special

code requirements in your area. Common railing height is 36" or 42".

Read instructions completely to get an understanding of how the product goes

together and how each piece affects the other.

Step 1 Determine the number of railing posts needed for your deck. Post

spacing is 6' or 8' on-center. Example: A 12x16 deck attached to a building with

a 4' access opening on one side will require a total of eight posts.

Step 2 Installing posts: Install posts by attaching the aluminum base to

the surface of the deck. Position the post so the fastener will go into the floor

joist, and make sure the decking is firmly attached to the joist at the location

of the posts. If necessary, use wood blocking as reinforcement underneath

the decking where the posts are located. Fasteners that hold the post base

to the surface should be able to secure to joist or reinforcement braces, not

just the decking itself. Note: When installing aluminum post on top of a wood

surface, screws must be lagged into at least 3" of solid wood. 5/4" or 1 ½" deck

boards do not provide sufficient material for a safe installation. If necessary, add

additional material to the underside of the surface.

Step 3 Position the post assembly onto the location where it will attached

to the deck. Four 11/32" diameter mounting holes are provided on the base.

When the final position is determined, mark the base hole locations. Remove

the post assembly and drill 15/64" holes in the marked locations into the deck

and reinforcement.

Step 4 Reposition the post assembly over the predrilled holes and insert the

fasteners (not included). Recommended fasteners: 4 – 5/16" x 4" or longer

stainless steel lag screws.

Step 5 Finish by sliding a post base trim (optional) over each post for a finished

look. Note: Installing the post base trim prior to installing the bottom rail is

recommended. However, the two-piece design does allow the installer to add

the post base trim after the rail has been installed. To install, apply a thin line of

clear exterior construction adhesive to the inside of the post trim where it will

contact the post sleeve and snap into place around the base of the post sleeve.

Step 6 Install baluster connectors to top and bottom rail using pre-drilled

holes. Do not over tighten.

Step 7 Measure the distance between installed posts to determine the length

Tools and Items Needed

• Adjustable wrench

or socket wrench for

bolts, etc.

• Safety glasses/

goggles

• Rubber mallet

Contents

ALX CLASSIC COMPLETE KIT

INSTALLATION INSTRUCTIONS

• Tape measure

Post

ALX Classic

Cap

Rail

Post

Base Trim

ALXClassic2.ai

ALXBalluster2.ai

In-line

Bracket

Baluster

Connectors

fig. 1

fig. 2