CenturionPro DBT 4 Manual do Proprietário - Página 6
Procurar online ou descarregar pdf Manual do Proprietário para Aparador CenturionPro DBT 4. CenturionPro DBT 4 16 páginas.
Imprimir página
INSTALL SIDE DRIVE
1. Install Side Drive on trimmer using 2 locking pins.
2. Ensure wheel is clean and fully engaged on Tumbler.
CONNECT POWER CORDS
1. Connect the DBT Model 4 power cord to a 15 amp 120 VAC circuit. Do not connect and
disconnect the power cord with wet hands. Do not operate in the rain.
STARTING THE MACHINE
1. Rotate and pull the red Emergency STOP button outward.
2. Press the green START Button.
3. Turn the TIMER dial clockwise until it is aligned with the desired trimming duration,
or turn TIMER dial counter-clockwise for continuous trimming.
4. Turn the TUMBLER SPEED dial clockwise to set the desired speed, start off at the
lowest setting and increase as required.
STOPPING THE MACHINE
NOTICE: In an emergency, hit the red EMERGENCY STOP button.
1. At any other time, Turn TUMBLER SPEED dial counter-clockwise to align with ZERO.
2. Turn the TIMER dial counter-clockwise to align with ZERO.
3. Press in the Emergency STOP button.
DISCONNECT POWER CORDS
1. Disconnect the trimmer's power cord.
CONTROLS AND COMPONENTS
BEFORE OPERATION
Read and understand this manual. Educate yourself on the location and operation of the controls. Familiarize yourself with the trimmer and how
it works before you begin using it. Know how to quickly shut off the machine in case of an emergency.
Your safety is your responsibility.
PRE-OPERATION CHECK
For your safety, and to maximize the service life of your equipment, it is very important to take a few moments before you operate the trimmer to
check its condition before each use. If you happen to come accross any issues, be sure to take care of them before you operate the trimmer.
Improperly maintaining this trimmer, or failing to correct a problem before operation, could cause a malfunction which could cause you to be
seriously injured. Always perform a pre-operation inspection before each use, and correct any problem.
Before beginning your pre-operation checks, be sure the trimmer is on a level surface, the MOTOR SWITCH is in the OFF position, and all power
cords are unplugged.
CHECK THE GENERAL CONDITION OF THE TRIMMER
Clean the Tumbler, Blade Sheet, and tension system. Look for signs of damage.
Check each control for proper operation.
Check parts for wear. Replace if necessary.
Check that all nuts, bolts, and clamps are tightened appropriately.
NOTICE: Keep all shields, Trim Trays and covers in place while operating the trimmer.
6
1 855 535 0558
cprosolutions.com
NOTICE:
The DBT Model 4 draws a max of 5 amps.
NOTICE:
Be sure to hold the plug when disconnecting the power cord from
the electrical outlet. Do not disconnect by pulling on the power cord.
BEFORE YOU START
SIDE DRIVE